Separate names with a comma.
I'm not a aware of them, I haven't been following BSB racing but I'll check them out. This Facebook page shows a video of the Powershift in...
There is almost certainly no chance of me ever getting a test ride so I'm trying to find out if anyone has any experience with them. They are...
That's exactly why I''m thinking of fitting one. I've had a below knee amputation of my left leg. There are 2 possible push button fitments...
Has anyone on here got any experience of fitting a Translogic power shift?
Good point about the tyres. Scottish Highland roads seem to be particularly abrasive Back in the late seventies I wore out a new Metzeler ME99 in...
I've been up that way quite a lot over the years. Most of the roads are quite good. The section between Hope and Durness is mainly single track...
I bought a Facom years ago when I had an ST4s but I've hardly ever used it since as it's quite bulky and requires room for fitting it which isn't...
Never seen it but I suspect that you're right. When my Supersport came back from it's first service it had lots of yellow paint marks next to...
I've never done cylinder heads but I have ground other surfaces using that method. There's nothing difficult about it. You need a genuine flat...
Fantastic to see these Francis. I'll definitely up for a visit the next time I'm up your wye :grinning:
I stopped at your place a couple of years ago when I going bye but the gate was locked and ye wirna in. I've become a bit disabled recently but...
You seem to have expanded your fleet a bit since I last saw it a puckle years ago Francis. I canna mind sae mony tractors, I only saw the grey...
Have the crank seals been replaced? Poor starting is often caused by worn crankshaft seals which are easily overlooked.
Blue and red coolants aren't compatible and shouldn't be mixed. They can form a gel blocking the cooling system. Best to drain the system, flush...
Sounds more like an electrical issue to me As suggested above possibly the regulator has failed. I had a similar experience with a 900ss a few...
I'd be looking for 140-150 psi for good bores and rings. Less than 120 psi definitely no good. If it improves with a squirt of oil down the bores...
Meant "previous" to Testastretta
I've never marked any belts either Chris. The point I'm trying to make is that the dots on the cam pulleys have no relevance to cam timing. They...
From 1098 on only the bottom timing pulley mark is relevant. The marks on the cam pulleys line up with nothing. You are meant to use a cam locking...
