Separate names with a comma.
I can't tell you from the engine number, but the tell tale is whether the cover plate between the two cam pulleys has 4 or 5 screws holding in...
OK... I deal with Translogic directly and they're not listing them yet, only the Yamaha units. Be good if they do though :)
I have the BlipBox on my 899. It's pretty good at doing what it's supposed to. I found it a little sensitive on stock settings, but it's easily...
I can get either Dibs or go direct to source.... Domino from Bike Torque Racing or JetPrime from motorcycleraceparts.co.uk
Db killer - 96413201A
As above… can’t go wrong with either Domino or Jetprime
It’s tight, but there’s no need to take the pulleys off. Warm the belts if the ambient is cold…. That helps. It’s not a good idea to pull the...
The engines, as are new crankcases, are supplied blank. It’s not usually the case the new parts get stamped with the old number as that would...
It wasn’t a 7mm, that’s for sure. Can’t remember whether it was a 6 or 8 though
Removing the intermediate section is easier if you pull the rear header with it still connected. Just remove the spring from the manifold above...
If you’re not sure with twisting the caliper, pull the pads out. That’ll give you loads of wiggle room
Used Translogic several times without any issues. Improved feel and virtually the same money as OEM.
In the scenario that the OP mentioned, I'm probably not as "independent" as would be needed either? ;)
As a rule of thumb, you should never cut and/or solder into either of the can bus cables. The voltages are low and super sensitive to the signal...
There was a recall on some of the Hypers to install a diode into the wiring to protect the CAN. I've seen a few knock out the dash and ECU. It...
Monster or super sport 750/900 or ST2. They have adjustable TPS so won’t be off anything that has a software tps reset. They’ll need doing the old...
Not aware of anything happening with Monster, but there's a couple more new bike "premieres" to come yet. One today and then another maybe next...
You’re in spec on all gaps for checking. The measurements you list as “operation” are the assembly figures. The 2 closers you have at 0.2 ish, I’d...
It’s a clips that retains the exhaust valve cable. Mounts over the cable end on the servo motor
The manuals were a little misleading. The figures never correlated and unless the motor was out of the frame, you couldn’t use the deflection...
