Separate names with a comma.
Well, yes, x will be shorter but that doesn't mean t will be. Levers innit? If his fingers are in the same position on the shorter levers and he's...
That's a rather splendid matching hat.
Thanks for the replies Leaning it will be tricky so I'll go ahead and drain it. Just wanted to know if I could avoid 1 messy operation.
As above, is it possible to remove the alternator cover without draining the oil, or will I end up with an Exxon Valdez incident in my kitchen?...
I use a signal processing app called Spectroid on my Samsung.
But what is true is that, as Derek says, you really need to pull the cams to check them properly, so it's a full belts-off fandango.
Looking at the schematic for the 97 916, the neutral switch was never wired in a way that would enable the bike to be started with the sidestand...
Maybe a wee split in the drain tube running through the tank.
Covid-19 casualty perhaps. Maybe in the worst possible way.
Interesting. There were hex heads on my 92 900ss.
Good idea, but I'd say that the small size of the hex recess on the countersunk screw is a pretty good indicator that they really don't need to be...
https://www.ebay.co.uk/itm/Yamaha-TRX-850-1997-Carb-Choke-Valve-Repair-Kit/333499117742?epid=653868543&hash=item4da618b0ae:g:oLwAAOSwwgVeMgJT
The Yamaha TRX850 had the same carbs. I once replaced the choke needles on my 900SS carbs as they looked rough, though not as bad as yours. I got...
Nice one, but never, ever, use OMG on this forum again.
Buy a bigger bed.
Yeah, he's right up there with Lukashenko, Putin, al-Assad, and Jong-un. Get a grip man.
Folk who moan about lack of range and lack of charging stations seem to forget that the internal combustion engine has 120+ years of development...
Might be time for a new timing sensor too. The magnet weakens with time and heat, causing the pulse to reduce to the point where it can be...
After all that work they go and tighten the tensioners CW, it seems. Wonder if it still lives, or met with a hideous belt-shredding end?
If the pin is not making contact then the pump would never run, because it is a 'pull down' control line. I doubt reseating the ECU will help...
