Separate names with a comma.
When you greased it did you check the spyder spring was FREE to turn on the spacer/washer with the small lip ? put some grease on this edge so its...
This is the set up on mine, now with a speed sensor off a monster a much nicer look than the one in the kit from M/M. brian. [ATTACH] [ATTACH]
This any good ? brian. [ATTACH] [ATTACH] [ATTACH] [ATTACH] [ATTACH] [ATTACH] [ATTACH] [ATTACH] [ATTACH] [ATTACH] [ATTACH] [ATTACH]...
The stem nut can be used to draw the old one off, yes you can leave it in place but once it`s pinch bolt is unscrewed it should be rechecked for...
You can change it without support, the stanchions will twist/spring back ever so sligthly when you remove the stem nut this puts a strain on the...
This is how i set mine 4mm as Andy said, D/P six ball and ramp set up. brian. [ATTACH]
The damaged tyre, any chance of better pics of the area to the left and right of it ? brian,
It sounds like you could need the single injector mod/chip, The T.P.S can be set with a multimeter if you have the time, look up i think its Brad...
You can remove the outer steel ring on some cam wheels to remove the belts but not sure which older models had this type the ring just taps off...
Can you not tap the steel ring off the cam wheels on this model ? brian.
Crank position sensor can give this type of fault. brian.
It needs to be a little tighter, a little oil or grease on the seal and a good turn by hand should be all that is required. :-). brian.
The D/P Slipper 6-ball ramp type requires 36.5 mm stack, 7-friction 3-mm drive plates. 7-steel drive 2-mm plates 1-convex plate 1.5 mm (i dont fit...
Is this just put a new set of friction and drive plates in OR have you fitted a new clutch assembly (hub-basket etc) at the same time ? brian.
120 till the light-916sps-1998. brian.
The spacer from the wire fuel pipes guide, from nearside/cam cap ?. brian.
The front disc`s could be sticking on the bobbins semi and full floating types that they are carried on try freeing them off and see if it...
Put the rubbers in boiling water a couple of times to get them nice and soft helps to. brian.
Fren tubo do a few sizes. brian.
The inside of the case looks like the rotor has been rubbing on the outer dia of the rotor/flywheel they look like that from new, but you still...
