Separate names with a comma.
Is the clutch lever on its maximum span out ? you will get a little bit more outward movement of the pressure plate before the lever touches the...
Is there any other good independent motor bike shops in your local area who all take it on and get it done faster .
When I serviced mine and as far as I know they have never been done before since new , each leg had 650ccs which was 135mm air gap from top of...
Seems like these fly by wire throttle bodys seem troublesome On a few other models , have heard the hyper 821 and 939 suffering with them also
Is the body of the cylinder clipping the chain stopping the push rid going up the bore square , turn back wheel slightly
So if clutch was fine after you doing spider and greasing balls would that say clutch stack height and operating clearances was good then ? It's...
Arrrr yes, sorry old rider just skimming through , yes muddier waters . So different spider could of altered clearances Yes grease on friction...
Just a few questions ...... the bike had no clutch slip when you last used with orginal slave cylinder ? Why would changing a slave cylinder...
Have you a car battery and some jump leads , even though it sounds good cranking over put the jump leads on it and try and let's see what some...
Did it with spring and spacer removed from leg , i will see if i still have the workshop pdf. File and post it up
How did you put led into injector ?, did you put each leg of the LED into the injector plug pins
When it's running on the one cylinder if you pull the non running cylinders plug lead off and hovver it over the spark plug can you hear the...
Would you say that if the bike was left to stand without the lever tied back that the air which will always want to migrate to the highest point...
Why does it still work when a system has been throughly bleed with fresh un opened bottle of brake fluid and there is no air in the system Tieing...
Arrrr the old cable tie trick , in most cases it's not air , it does not make the brakes anymore powerful just takes out the travel from the lever...
Dealer would not fit belts not supplied by themselves , they could not give warranty on the job
Run switch on ? 11.7 volts with ignition switched on ?
Post up the dyno print if you could comfy ...lets have a look at how it looks
Where the two heavy cables go on the starter solenoid pull the rubber covers back , make sure bikes in neutral !!!!! or you will end up in the...
Whats wrong with just putting some tape over it ...........
