Separate names with a comma.
I would have been tempted to replace the oil cooler as well if you were that far into the job.
Does the pressure rise steadily and in a linear relation to rpm?. Unlikely to be the relief valve but you could shim the spring out for testing,...
chrisw is the man to speak to, he helped me out with a an ecu problem on a Multistrada a few weeks back (thanks again!). The HW number is very...
I always do a final check with someone sat on the bike to make sure it's not too tight.
Considering what they charge per hour you'd have thought they would give you a decent printed invoice. If we get a bike in with a fault we can go...
Would be interesting to see the pistons and cylinders, sounds like one has possibly partially seized in the bore causing the back wheel to lock...
At least they've found an engine for you, rebuilding that one would give you nothing but trouble. The noise is normally the piston top smacking...
The seal relies on 2 ceramic disks that are pushed together to seal the impeller side of the shaft (one spins against the other), you don't want...
Amazing machines!.
Did you get a written list of jobs done?, possibly on 1st page of invoice?. Our invoices give a detailed list of all work carried out and list of...
Loctite would be fine as long as it doesn't get on the mating surfaces of the post and terminal adaptor. You may have been better bolting the...
Would have been £75 at our spot (or free if it was where we'd been already)..
Looks like a 2 part sprung ceramic seal setup, the coolant should not mix with the oil. Where the tell tale hole is located is in "no mans land",...
Did you have the valve clearances checked?, if so it's more than likely a cover gasket that's failed. Can you post the original invoice up?.
Deffinitely not normal for any waterpump to leak, the hole is a "tell tale" so you know the seal is failing and to avoid coolant mixing with the...
As said above, if he had the cover/ part off as part of the service then it should have been a free repair secomd time round.. Maybe best to go...
Yes, when you release the clutch in gear with a faulty stand switch it would stall the bike (if ecu thought stand was down)
If the damage is that severe I would decline anything other than a new engine personally, soinds like it's not salvagable anyway. The shop...
It's a shame but to be honest ever since WD went over to America the show's gone downhill. I much prefer the earlier ones (Morgan and TVR...
We use Wurth Matt exhaust paint, really good coverage and finish. Their black gloss is also excellent (none heatproof though). [ATTACH]
