Separate names with a comma.
I'd be tempted to replace the relay anyway, the minature ones do tend wear out. What make is the battery?.
They do spin over quite slowly. How old's the battery?, 3 years seems to be the norm nowadays. Get a good quality replacement if you do change it...
We had a VJ23 RGV 250 SP in a long while back when we imported from Japan. In the same batch was a Honda NSR250SP MC28 (Smart Card). Both lovely...
You can stack shims, Id be tempted to use two as equal thickness as you can get them rather than lots of thin ones. 8mm does seem quite a lot,...
I'm fitting a Chain and Sprocket kit to an Aprilia RSV-4 tomorrow with a Supersprox rear, will see where the parts lad had ordered it from.
You can feel this to a certain degree on all modern fuel injected bikes, there's a big hole in the fueling where they've been mapped to pass Euro...
It's not uncommon to have pops from the exhaust on overrun after fitting less restricted/ baffled silencers on carbed and efi bikes.
Air in hydraulics would cause poor clutch release but would have no bearing at all on the clutch slipping..
Can you measure your original slave cylinder fully compressed (where the pushrod seats) to the face where it bolts to the engine casing and do the...
I've never seen this on any single sided hub before, as said above it's motor than likely due to incorrect torque of the wheel nut at some point....
0.5/1.0mm is very marginal between a dragging clutch and a slipping one, I wouldn't be happy with that and would prefer the bigger travel of the...
If it's a carbed bike and you want to stand it up drain the tank and float bowls completely. If it's efi you'll never get it all out so a full...
It was a garage ornament by the looks of things, new owner wanted to hear it going but couldn't get it started. It had 1/2 a tank of fuel in but...
£750 is a bargain imho, a lot of time involved and time is money!.
Best of all worlds there, good choice!.
I would say the 25 will go with a 525 pitch chain. Surprised they offer a 15 pitch in your fitment!.
I'd say you're best off starting it once a month to; A: get the fuel pump spinning and B: moving the stagnent fuel through the fuel lines and...
You can tell just by looking if the fluids gone off, goes from translucent to dark gold and eventually black!. If the foil seal is still intact...
Post a picture up of the caliper, if you have no rear brake at all odds on the piston in the rear master cylinder had stuck at the top of it's...
Renthal will be the same fitment as OEM rear sprocket.
