Separate names with a comma.
I'm wondering, before I face stripping the engine, is this a known symptom of shot main clutch bearings, where at full engagement the output...
Thanks Rider... yeah id very much appreciate experienced eyes... and im well able to lay on the hospitality.
Its the right chain. Yep it looks like its ‘riding up the teeth’ - what im calling binding. Thats leading to thinking its gears ....binding under...
Interesting... this sounds like the sort of thing - something to do with the meshing. Answers to your queries: Not sure that a shaft bearing...
No, boss is facing inward. Wish it was that!
Yes (to qns 1 and 2). It stalls when engaging engaging clutch in gear. The last paragraph: i mean to say i never before experinced a reaction of...
Enables me to get moving without stalling - i cant let clutch fully out without stalling due to chain bind. Is not due to lack of power, which i...
Many Thanks. Engage the clutch and it stalls ... (no brake) where the chain 'snatches'.... I would perhaps better describe it now as 'binding' at...
What do you reckon? Confirmation: 1. :upyeah:Coasting in neutral, and in gear with clutch pulled in and riding short distance with clutch...
All checked. Tank was cleaned out thoroughly, and rechecked/emptied and rinsed. Carbs stripped and rebuilt. Could be water in the fuel now. I’ll...
Thats a great point. Thanks Rider. I’d say from memory, yes smooth. What would be possible cause(s) from motor then? I will take another closer...
BTw, Id like to ask the opinion of Arquebus on this, but his membership is now gone, and I see he has re-appeared as guest status ‘ghost rider’ -...
I had taken the push rod out, yes and the bearing was good. I’d like to watch the clutch whilst running, but its a wet clutch (and an opaque...
hi Mark, yes it is telling. I dismantled the clutch plates, examining the friction linings, tabs and slots and splines - all good. The bearings...
I badly need direction in troubleshooting this problem. I am stumped. :cold_sweat: Recap of The problem ——————————— I can basically describe it...
Its OK - I can see that it does separate, although I have only got so far - I might need a press.
Question as per title.....Because before I start heating and bashing to separate mine, I think I may have one! And, if so, what do I do to join...
Cheers, Good recollection you have - I also recall them being set at about 1mm below. I pushed them in a little further - the method was push a...
Can you tell me how your cush drive to sprocket carrier is set? I'm replacing the cush drive pins and rubbers on my '97 supersport, I put the new...
So test: - AC VOLTAGE at PICKUP COIL - starter motor engaged Disconnect plug form CDI; Should be 0.3-0.5 VAC. peak voltage produced...
