Separate names with a comma.
Investing some serious cash into this bike eh! Hope you're keeping all the original parts. Also, i haven't seen any for sale in quite some time,...
Good information, i never thought to remove that rubber boot and check for any corrosion.
I ended up changing the pads, the old ones where all corroded. I took it for a spin and it still rubbed. I went to adjust the lever play and...
I can and did remove the pads from the caliper without removing the wheel. These have quite a bit of surface rust on the back of them. I have...
I don't have much play in that lever to be honest, and once used even less so. Maybe i will check and re-adjust. I also noticed that the pin that...
Boll**ks, i've never had to take the calliper off this bike to inspect dirt/grime etc. I've just looked and noticed you have to remove the rear...
I just noticed that my rear brake is sticking intermittently, i noticed when i came to a set of lights. By the time i pulled over it had become...
Any excuse to play with tools & take the bike apart!
Very tempting upgrade, just when i thought i was done!
How much did it all work out to cost?
Bad News is that the sensor did'nt fix it. I started to carefully peel back the wires and all good up to where it goes into the main loom! Then i...
Cheers for that, I've just ordered one. Hopefully this works and i don't have to start cutting into the wiring loom to find a break in the cable!
Mine is a Bosch 0261230030, i might just take a punt on this been faulty and purchase one. I don't fancy sticking a multimeter in those pins to...
Im just going to keep this updated, future ref and all! That cable is top notch, with the instructions from the website i connected first time....
That's good news. I was also trying to figure out the difference between Ducatidiag and TuneECU, it looks like you anticipated my next question!
Do i need to change the pinout like below, or is this cable all set? You'll see at the linked page below a picture identifying the operating pins...
Nice one, thanks for the help. I have just ordered one. Hopefully i can find out what the issue is, depending on how accurate the fault codes are.
Would this be the cable Diagnostic Interface for GuzziDiag JPDiag DucatiDiag I see mention of checking the polarity, i presume these will be all...
Doing a bit of reading, i think i will buy the cables and download the software to read the codes. Pretty usefull going forward.
Yeah, its on all the time now. I don't have the software, where do i get this? I presume i then need to buy a cable.
