Separate names with a comma.
I had this on mine. Although slightly different situations. When riding along the hazards would come on and the generic warning light on the dash...
The CTMOTO sockets are really good quality, the machining is a work of art. A word of warning is the material is not as hard as the laser socket....
I have the Base model with monochrome display rather than the TFT. So it is slightly different. When I turn the ignition off and hold the button...
John. Thanks for the advice. I have tried holding the switches in with a screwdriver and it made no difference so I think the solenoid is fecked...
The two bolts which tighten the eccentric hub (10mm hex) are 35nM
Thanks for you input. I have been trying the steering lick most days to see if the status is the same. Upto now I have not had a single issue with...
Cheers buddy. I am going to speak with the dealer today. Fortunately the local dealer (Snells at Alton) are really helpful so will see what they...
Had another plod through and to confirm a few things; 1. All fuses are good and bike battery is fine when standing an cranking. 2. If I hid the...
Laava thanks for your input. Can't really so this until next weekend. I would be concerned if this fixed it as next time it could lock in the ON...
Hi chaps. I have base model 1200 DVT 2017. Bike has been fine until now. It is used pretty much every day with the same routine. Go to work put...
If remember correctly. Take out both R clips and then the pin taps out from the left side. Seem to remember it is a bit fiddly putting the pins...
I have hopefully attached the steps for the rear brake pad replacement from the manual [ATTACH] [ATTACH] [ATTACH]
With the rear I changed the pads without removing the calliper just jiggle the caliper to get them out and back in. The front ones are easier on...
I had a similar issue where the genericamp would come on. Turned out to be a dodgy hazard light connector in the right hand switch gear. Dealer...
I didn't need to remove the caliper managed to slide them out and back in ok with a bit of jiggering
I have just changed the rear pads on my base model dvt. It really is a five minute job. Assuming it is the same for the S model. Remove the...
Also Sw Motech do an top box plate which you fit to the bike. You then buy an adaptor plate to fit the type of top box you have. The adaptor plate...
It works using a RF fob which you keep on you (this is what they refer to as the key..). When the bike moves and the fob is in range nothing...
I have fitted a monimoto to my multistrada and have been impressed with it. Make sure it has the latest firmware installed as they have done some...
@pacix - there is another option. I brought a second hand set of panniers with grey lids. When I got them they were scratched although not as bad...
