Separate names with a comma.
easy job drop me a pm
let me know what you need and we can look at it
It’s being delt with fella. Unfortunately I don’t pack and send everything personally myself.
I can’t recall
How thick are the lifter plates?
i might have missed this but.... what is the stud for?
I’m so glad it wasn’t too much of a faff.
Thank buddy.
if anyone has any issues let me know or if they are not happy we will try to sort it for you.
it's my fault I didn't get the OEM pin here until we had finished the machining so we trusted the Gilles parts to be right or have enough play for...
yes if they are all the same as the one I have here they are about 0.25mm off-center.
The measurements we worked to were exactly to the Gilles ones. The OEM block is baggy in comparison it seems. If your happy to do so all you need...
You can see once I drew a file over it a few times the gap and it goes in [ATTACH]
Ok I’ve had a measure up of the pin that I have here and I have noticed on mine the flats are not machined Bob on centre to the spinal shaft. I...
Oh dear. Let me look at the ones I have here. All too good to be true.
I can’t see what your showing me
Possibly. Maybe someone has the instructions from the Gilles sets.
Or maybe they are supposed to go right to the far side.
I’m not sure on the intended as I just followed the Gilles design. I’d assume so.
And one piece would take over a day to print
