Separate names with a comma.
The bezel is steel and not alloy, its a pig of a job and difficult to put back on as securely as it was. I have painted a needle with success...
A while since my last post. Been busy with life, but thought I would share my latest work. Got the shimming done after using the donor ST2 gearbox...
Bike colours https://www.bikecolours.com/
[ATTACH]
I have an ST2 lid you could cut up, its higher than the SS but the base is the same. £25 inc postage
Nice touch!
Merlins blood does a great job on wheel/caliper grime
The issue is getting them out, they can be in extremely tight, may need heated and to unscrew them you need a double nut at the end, which there...
Thats bad, first time Ive heard negative about them though
Ive found their products great, Ive had two looms and a starter. I havent however ordered anything else. Sorry to hear of this quite poor service
No, sorry, I guess it wasnt exactly the same. I had a coil wired the wrong way round, but it was my fault. A simple swap round of the polarity and...
This exact issue I have had
The good ones have an 'O' stamped on the end as per below [ATTACH] [ATTACH]
The studs should be dark in colour. If silver then they are stainless and are prone to snapping so are best replaced. It has low miles so hasnt...
A 39 will give a nice improvement on acceleration.
Id give you £50 :)
Holy thread revival!
Great news, its better to keep it
They could be fine, Ive never seen them or heard of their use before so cant help. Id go for Ignitech too though. You can set to standard Kukosan...
I have a 2002 900ie, but its got the beefy swingarm on it. I have a special 1993 carby which the Metmachex is for
