Separate names with a comma.
Is anyone aware of a different model that uses the same base plate I.E. st4s or monster or anything ?
I think you're right with the thickness . Im going to by a base plate bore out the original fittings , probably right through , and fit alloy...
where will i keep all my points .
Did you buy it then Steve . looks as good as it could get .
Mines different . I bought it at the same time i bought the clutch which was in 2008 . Handle sits on or under the foot rest . [ATTACH] [ATTACH]
Has anyone ever found an outlet that sells the 48 tooth sintered wear plates separate. I have loads of the steel ones lying about and would like...
I use this clutch and yes I had to buy the expensive tool. Couldn't see any other way to do it without one . I can get some close up pictures of...
Not yet but I'm sure it's doable and I will get round to it .
Yeah well take it like that if you must .
Im not that sure that my 999R has any paint on the casings come to think of it .
Never happened to any of mine.
But yours is shinier . :)
This is a Ti termi that is riveted and has equal inlets. Bit mucky but you will get the idea. [ATTACH] [ATTACH]
You could slim the RG bracket down a bit at the back . Or cut a small piece of the cover to allow it to fit .
I haven't seen a one as bad as this . Its as though its been ridden through something corrosive that has set it away . If you look at the swing...
Looks like its down the left side too. It would have to be cheap for me . To re-paint this much it would have to be an engine out . Either its...
Sometimes the sat nav in my toyota , not oem , goes a bit mad and says I am doing 780 mph or 650 mph just depends on how it feels . I get the...
Its not an easy job as the parts that have to come off need special tools and the flywheel nut is tight . 270Nm to torque it back up .
Beats me why people cant just stick to the thread and answer the question . Fuck all to do with lap times , racing , scrutineers , race series or...
If you think thats tight wait until you get to do the flywheel nut . Thats 270 Nm 0r 199 lbs foot .
