Separate names with a comma.
I rattled these off using 1” x 1” tube. Not as effective as the ones above but good enough for stripping the bike down. [ATTACH] [ATTACH]
@Tobytyke, is that you on the left? :-)
No, I don’t think they produced a 996R printed cover.
Yes, that’s it! Worth good money! :upyeah:
Castlefranco, I’m pretty sure that’s where the company was who made the special ones.
In fact, if you could swap the last 9 round to make 996R, I’d snap your hands off! :-)
They were made by a small family run company about 20 miles outside Bologna and haven’t been made for the best part of 20 years. Wish I’d never...
If that’s the cover with the ears (mirrors) it’s a bargain!
Is that the Mancunian off Facebook? The one with a Cat N…
Good to see you here, Adam. :-)
Just picked my paddock stands up from the powder coaters and minted them up a bit. All ready to start the next bike project hopefully sometime...
I can’t remember mate but it has been done / mentioned on here a few times. I’ll see what I can dig up…
Try searching for the KTM rebuild kit. They used to do them.
As above but if you still have a kink or too much of a bend, push a spring inside. [ATTACH]
Just curious as to why you didn’t go down the Translogic route? Seem reliable enough…
How did you guess?
Sure I’ve got one kicking around.
I haven’t ridden abroad for a few years ago so have really no idea… We’ll see how it goes :-)
I’m not sure either tbh… There’s a group chat for this tour and the organiser advised us not to use the small plates and to also fit the UK...
Not worth the hassle of potentially getting pulled while in Holland, Belgium and Germany. I really hate it but it’s only for a week or so.
