Separate names with a comma.
Paul, Head work - Chris at http://www.cjsracing.co.uk Think most would agree. Had mine done a while ago presume still going. Bristol area. Cheers Gaz
Paul, Good luck with restoration, been on with mine about 8 years (poor effort I know). If I can help in anyway please ask. Will watch with...
Have a search for rejuvenating rubber parts. Things include heating in hot water, soak in isopropyl/wintergreen oil, spray with silicon spray soak...
No problem. Agree with getting OEM part. Are there any second hand ones on Ebay? Cheers Gaz
Sorry, must have been the light, the 2 profiles are more of an internal barb tail. I have revised the sketch. [ATTACH] Cheers Gaz
Sorry just seen new post. The sleeve is not symmetrical. There is a definatr round profile on one side and 2 lower flat triangular profiles on the...
[ATTACH] Cheers Gaz
[ATTACH] Will measure up best I can but it's not just od I'd and length. There are various steps and shoulders. Cheers Gaz
MonkeyDog, I recall reading (I have not done it) if you fit the oil cooler higher you will not be able to fit the brace (item 27) if you stay with...
Yes, correct I knew there would be something. Bike in bits so wasn't thinking about that. Cheers Gaz
While waiting for a closing shim and closing shim measuring tool to arrive - I had a theory. I thought "you have the valve, you have the shim, you...
Yes it is difficult. I think unless there was a definate difference in colour which is the oil staining on the exposed outer top part I would have...
Thanks both for that, that has given me a bit more of an idea. I think Ive seen it mentioned before that the indentation is more pronounced on...
There seems to be a difference of opinion on reusing collets if they are ok or installing new with regards to bedding in and valve clearance. I...
Keith, Yes I have a large thick flat washer, I will take the cams out and pull them in with a "G" clamp over the head until the washer contacts...
I think I knew the answer really. Pressing the seal in flush gives 2.5 / 2.7mm to start of chamfer. [ATTACH] [ATTACH] I was about 2mm in so for...
Basically, have I knocked the seal in too far. There is a bigish taper on the bush and think the seal is too far in and not sealing on cylindrical...
Took the plunge to pull the rockers out and check the shims and side clearance. Ended up with about 0.6 give or take a bit on both sides so glad I...
From memory the rear wheel (on a SS) had a cone washer spacer. Make sure this is the right way round I think its cone inwards. It may or may not...
Yes thanks for replies. Sorry should have check continuity, I did think about it but thought it would not work because the pluger was touching the...
