Separate names with a comma.
I hope it was that. I only recently changed the stand so it stays down, rather than spring back as originally designed. I'm having thoughts about...
I checked the bike in detail and removed the slipper clutch completely, no sign of any damage. Only thing I found was a small amount of slack in...
I will check when I get home, I have the 3 spoke brembo wheels.
Did your wheel lock-up at any point? I have not had the wheel off to check yet, I need someone to sit on the bike and hold the rear brake for me...
That all makes sense Red998, I was maticulous with the installing of the clutch, correct stack height etc.... I have since put back the original...
I have closed the garage doors for the night, will check tomorrow Old Rider. Is it possible to get them out of alignment? I think I would have...
Yea that was my concern it might be doing that!!
All bought at once. I know it's not ideal, but is it ok run a bike on a paddock stand at low slow speed?
Its a new chain!! + sprockets and renthal carrier. the lesson I'm learning is make small changes at a time and then test.
I agree, it should activate under engine braking load. I could however, on the paddock stand, feel it doing something through the clutch lever, it...
Thanks Bradders. Yes the cluncking was loud and I could feel it through my seat. It was just a gentle ride, I had just fitted new discs and pads...
I will check the plates again, I installed them exactly how they came from sigma (48T pack). I did strip them after it happened, they all looked...
I had thought about putting it back to std. If the clutch locked then surely my only issue would be that i would have a problem changing gear?...
Thaks all. yes I have checked the Sigma clutch again, took off the pressure plate, took out the plates, no sign of any issue. The center clutch is...
Can anyone confirm if this is right or wrong. When bike is on paddock stand and in gear, rotate rear wheel CW a few deg to take up slack in...
I have a Honda EU20i, runs like a dream and quiet, will be more than enough for 2 sets of tyre warmers. I have a small 900w kettle for making...
Thats very kind of you Andy, I was going to get some titanium ones if not too expensive .cheers
need some better bolts for the clutch cover
[ATTACH] [ATTACH] [ATTACH] [ATTACH]
Sigma 48t slipper clutch. Our range of slipper clutches Got a small discount from Neil Spalding but still expensive, hopefully worth it though
