Separate names with a comma.
Hi all. Im just changing my headstock bearings on a monster 696. Getting the lower bearing race off was unpleasant but now done. When it comes...
Hi all Does anybody know if any other swingarm will fit a 797/1100 monster. The hypermotard 796/1100 look the same but are they? I'm replacing...
Hi all. As part of my "get focused and sort your projects out" campaign here is a set of ST4 forks I purchased as spares for my S4. As the S4 is...
Hi all. Due to being an idiot 99% of the time and not being able to make a plan and stick to it here are some brand new 916 bearings and rod...
Hi all. I have an M600 frame. I have a 696 engine. I was thinking about a cheap "shed build" while my S4 eats more money and time than I...
Hi all. I recently purchased a new set of bearings for engine reassembly and it dawned on me... Would there be any chance that my crank is...
Hi all. I need new connecting rod bearings for my S4 and I have seen a used 996 crank and rods for less than the cost of a set of bearings and...
Hi All. I was thinking of fitting an S2 crank for a little more capacity on my S4 as I rebuild the bottom end on it. Does anybody know if...
Hi All. I was looking at fitting a 900 crank to my S4 for some additional stroke. If I go for a pre ie (carbed M900 crank) will I run into...
Hi everyone. Firstly, an apology. None of my questions seem to flow and seem a little "up in the air". Ive just been searching and found my own...
Hi all. I have been looking at building a new motor from cases and I have seen that I can build up a 916 engine from 748 cases. Budget is a key...
Hi all. I was looking for a set of 916 cases to start the build of my S4. I then realised I could also use 996 cases. Now I see a 998 monster....
Hi all. I am looking at building an engine up but I am trying to establish the differences in the engines (apart from the number of valves). Can...
Although I have been registered on the forums for quite a while I've never said hello or commented or even liked some of the amazing bikes I see...
