Separate names with a comma.
It wasn’t bad to be honest, I did intake a HUGE sigh of relief!
And this is how she stands as of today, buffed the nose, screen, seat unit (after stripping and thoroughly cleaning) and refitted. Also re...
Finished up the front end by a good deep clean, new replated fasteners fitted and headlight stripped, cleaned and redone the blacking around the...
Next up was the swing arm and hub to tackle. Again, thick with chain grease and crap and the carbon was so dull! mixture of autofiness eradicate,...
Genuinely was gobsmacked at how the callipers turned up. I stripped them, soaked the sdoc on them and use a toothbrush to get all the grime and...
More general stripping showing the extent of its filthy ness. Thanks to product suggestion from @rob lewis on the bilt hamber auto wheel I was...
And fairings off to clean up under the plastics to make a start and decide what needs doing [ATTACH] [ATTACH] [ATTACH] [ATTACH]
There it sat for a few weeks as I had no room at mine for it so it lived at my mums for a bit. But headed over to give it a sdoc100 wash and see...
So head up to Scotland and first impressions were oh shit, what a state. The pics made the bike look good, and whilst it was all there, it was...
Wasn’t planning on doing any kind of thread on this bike, as I couldn’t really be bothered and didn’t plan on doing too much to it - but as I’m...
Take it they are only used one time? Almost certain I have the pliers to close them, if it’s the same as my Agusta use
Question on fitting these, do I need new fuel lines as I am reading that they are special types of hoses or something? or alternative clips ok?
Oh yeh there are these https://rover.ebay.com/rover/0/0/0?mpre=https%3A%2F%2Fwww.ebay.co.uk%2Fulk%2Fitm%2F333178511478
Yeh but he couldn’t remember where he got em from last time I asked
Looking to swap out my plastic ones which look way past their best. Can anyone tell me where to source theM from please? I remember something...
My floor got a lot dirtier!
Before and after shot! [ATTACH]
Sorted! was exactly that, spoke to Rich at Louigi and he suggested that there are times when the tolerances are just a touch out. [ATTACH] [ATTACH]
The plating has been finished off properly on this, but I did notice late last night a small burr on the splines which is where it’s picking up -...
They are replated, but in honesty they are some of the best plating I’ve seen. So close to original
