Separate names with a comma.
What gauges are they? Most need to have dampers in the pipes?
Yes. On the 749, the balance is mechanically set. Air bleed screws are used to balance and also control idle speed. Richen (screw in) them up to...
Check resistance between the individual cables… basically checking for a short
I’d pin out each wire from one end of the loom to the other, connector at a time. Do the sub loom in the picture, but also the connector back to...
Are the fronts working ok? If so, that probably discounts a dash issue. That’s the driver for the fronts and the receiver for the switch signal....
The new red connector is for Euro 5 compliance. You’ll most likely going to need a trip to the dealer tbh.
SOLD
Careful with the the southern references Chris….. I’ll get deported if the locals up here think I’ve defected :p
Glad you’re happy Anthony. It was good to meet you and the family. We found the harbour, fish and chips and a paddle before we headed back. It’ll...
I've still got this For Sale - 748/853 For Sale | Ducati Forum Not Yellow and far from stock (if that's what you're after) but it's sorted and...
One of the switches, front or rear has been knocked or damaged. Probably front by the sounds of your damage.
Could be the dash then. Waiting for it to fail is one option, but not the best. If the higher voltage triggers a “Hi” warning then the dash along...
Like Chris says, the dash info is fed from the Ecu. If you read the voltage with diagnostics you should see the Ecu is seeing the higher voltage.
I actually worked that out once........ yes, it blocks about 20% iirc. IMO, the damage that can be cause to the fins etc. is offset by this, but...
£388 inc. the VAT for a new one.
I can tell you tomorrow….. I know it’s all relative, but I don’t think they were “that” much, especially when compared to what people think used...
Mine did the same last year…. Tbh, I’d pull the pin and get a new one. They get battered and full of road debris. The lower rad does the hard work...
It all comes down to your tool kit. If you’ve got nothing that will fit in the space, then for what it takes to remove the fairings and tubes,...
they're generally not much for a new one
V4 no longer uses an exhaust valve.
