Separate names with a comma.
The kit is still showing on the order system? I'm not 100% but I think the part number is the same for LH and RH peg. 96280021A. £89.90 + VAT
Early bikes, pre 2005 or so had the oil line running tight into the cylinder with a Y-piece that was bolted to the cylinder. They also had hard...
I'd only use genuine ones or Exact Fit belts. Only ever seen poor condition or failed Dayco's. I know folk have used them, but it's down to you....
The air box lids are now longer available from Ducati, hence the silly prices being asked.
Kind of... Termignoni have brought out there own remapping tool and coincidently called it upmap. I think the full name is T800? The original...
The UPMAP isn't available as a spare part. If you don't have the original key that came with the bike, then in truth, the only likely solution...
What's the part number of your new panel?
899 seat cowls..... had some fun with them. They aren't any longer and weren't available for very long in the accessories catalogue. The ones...
The replacement panels are pretty much spot on as regards matching original. What you have with older panels is UV degradation, polishing etc. The...
Al the above sounds quite possible. That era of bikes are quite often registered later than they were made. It's always worth ordering off the VIN...
15W/50 grade should be used as the DVT system relies on reliable and stable oil pressure and control. Nothing to do with Italy being warmer....
Gel batteries don't like being left on "drip" charge for prolonged periods. The cables will help for sure, but I'd get the battery checked with a...
I see quite a few that have failed like yours. You can drill it etc. But it is possible to flick out the other end and rotate the brace itself to...
When I had my 748, I tried the no flywheel route and couldn’t get on with it. I had to raise the idle speed and it just didn’t “feel” happy. That...
If the bike is out of warranty, and you want to supply the belts, then I’m ok fitting them. Yes, I only supply genuine belts, but as a service...
Is the eprom in the correct way round?
Valves aren't due 'til 18000 on the 821 motor. Little point in doing them early as they're a mileage related item and wear will happen with miles....
Yes, but it should only be energised for a short time, then drop out until the engine starts. Is the Ecu earth cable attached to one of the...
The ECU runs the pump for a few seconds to prime the fuel system and make sure the pressure is there to start the engine. As soon as the engine...
Gear sensor is failing. Recalibration will/may help for a short time, but I’d get a new sensor fitted. Save a return trip to the workshop
