Separate names with a comma.
Great looking bike and restoration. My only very minor gripe is the alignment of the end cans relative to the seat unit, as they seem cocked off...
Ducati Desmo 250 Yamaha XT500 Bimota SB8R
Looks great. Enjoy.
Finished wiring up the internal wiring from the control box in the garage to the exterior junction box, which is now mounted in place. That just...
Bought some Toupret Masonry Repair filler for the small blow out in the render and I have to say it's amazing stuff, sets rock hard in 24 hours...
Can I ask why you didn't remove the frame from the engine to paint it?
My wife labelled it as my mad contraption. I prefer to think of it as something Q might have cooked up. [ATTACH]
On the software side, one of the advantages of the Afterburner digital controller is being able to control the heater from anywhere, not just over...
So with the flight case element of the build complete, here are some images of it in it's entireity. Pretty pleased with how it turned out....
Exhaust paste will ensure a gas tight seal when fitting the pipe inside the case. The glass fibre matting/sleeve, was cut to length before being...
Here are a few pictures of the completion of the flight case build that I omitted to post up earlier. Laser cut silicone gaskets will fit...
Spent yesterday afternoon drilling through the wall to install the external junction box. Decided to bite the bullet and bought a pretty meaty SDS...
Welcome Neil. Another gratuitous excuse to show mine as well. [ATTACH]
I am a fussy barsteward, I must admit.
Back from a 3 week holiday in NZ. Finished the external junction box. The momentary switch means I can reset the fuel usage to zero whenever I...
You can run an adaptor lead connected to your OBD connection under the seat into the cubby compartment under your rear seat pad. That way you...
Spent a few hours yesterday afternoon, soldering and insulating the seven wires that go from the external junction box to the heater and...
Air duct adaptor plates back from powder coating. [ATTACH] Initial mock-up of the new 15 litre tank completed. I have yet to add the inline fuel...
I did in fact. I just included a link so that others could watch it. :upyeah:
U$S59,000 for a road going complete bike. Looks great on the video and US$28,000 for the engine. Considering they are handmade not that expensive...
