Separate names with a comma.
Don’t use it for anything but charging the battery. The wiring isn’t designed to be pulling higher current.
It's not so easy on the 999 as the older bikes. 999 starter motor has a support built into the end cap that is bolted thru a bush in the engine...
There’s a lot more to exhaust design than routing and making them look good. On a 4 stroke, individual pipes rarely work well. Header length and...
The Red key isn't as "sacred" as it was on the 749/999 era bikes. A new one is £47. It'll need cutting to match your active key. It's a...
You can draw oil out of the filler cap as well. 6mm pipe on a decent size syringe. Cleaner and more accurate if you've just got a little to take out.
Looks like a 999/749?.... I've done a few in the past by taking the earths in to 2 or 3 crimped eyelets (main earth into a single by itself) and...
More than likely Andy. Once the season quietens down, we've got to keep busy. Happy to take a look.
I'm looking at doing a suspension service thing over the winter months. Probably going to be a fixed labour price plus parts as required. Just...
I've not long since picked one up off ebay for a 748. The guy seems to have most models covered. Fitted and worked a treat. Seller is...
Only the very early upmap were plug n play. The version you have requires the Ducati diagnostic gear to install the updated map. If it’s a used...
Alternator is 330Nm +/- 10%. Use a new nut but don't use an impact gun to finish it up... If 270 is all you have, then use thread lock (worth...
Give us a call and I can sort it out. 01623238944
The stock forks have pressurised bladders in them as part of the damping unit. They've failed. End of. New forks aren't silly money from Ducati...
Yes mate. I have one left in stock.
9Nm.. One has a copper washer underneath it. Don't miss it out ;) You can help the seal by adding a little threebond to the screw thread on that...
The clip in question is an outside clip. The clip in the drawing does look like an internal, but it clips over the sprocket carrier boss. Maybe a...
May be the case yours has the earlier hub and the clip could be number 11 in this diagram? [ATTACH]
Thanks mate. @Exige can we give them a go then :)
Thanks Stuart, but I don’t think they’re a straight fit. Clamping diameters differ iirc. Don’t want to go down the route of machining or shimming...
Should get them swapped in a hour tbh. From what I've seen, little use seems to be the curse of them. If you use it, then you should be ok. If...
