Separate names with a comma.
That was a Prince number wasn't it?
If you don't want it on the shiny side plates of your chain............. .............don't spray it on there. I used to use Wurth Chain Lube,...
Can't tell from the photo..... Has the engine number been removed or was there never one there in the first place? Or maybe is it a new casting...
I usually say 'ally'....that's not alloy; ali, aluminium or aluminum...... ..... you can make up your own mind what I effing mean. It isn't hard...
I hadn't started my bike for about 4 months....possibly longer. Lugged it out of the workshop yesterday when it was freezing cold, realised I...
Nothing wrong with Maidstone Motoliner....very good work and not too costly.
If you can afford about £100 - £150, why not have them nickel plated? Although it is bright, it isn't as 'white' as chrome.
I just made a nice job with clear silcone gasket goo to make sure mine stayed in and didn't corrode.
Same as me, but everyone else calls us those old bastards.
Not another oldie? Do you remember Muffin the Mule? That is actually a criminal offence.
Cactus Jack......based on Roadrunner I suspect.
I checked it with Ducati Italy as well, but I can't find the emailed reply at the moment.....It is in an archive folder, but I can't figure out...
It should point away from the tank, gaz. I explained why earlier in this thread. However, see below if in doubt. Note the join in the valve in...
I doubt very much it is filler in the tank hump.....how could it have got in there?
Bloody hell, I thought he had died recently. (Ginger Baker I mean, not sambigbollox)
600 and 750 has the 4.5; 900 has the 5.5. But as the swingarms are the same (ally or steel) they will all fit.
Broken speedo/tacho cable maybe....the broken end of those can have lots of little sharp bits which might cut through whatever the block is.
Maidstone Motoliner did three front wheels for me in 2012-ish. Straightened the three having removed discs and tyres from one (and replaced them...
How in hell did filler (if it is filler) get so far into that breather tube? I would try cutting the end of your pieces of wire at 45 degrees to...
A wire coat hanger might be easier to push in if you are careful and stop if it seems wrong, once in you could try rotating it to clear as much as...
