Separate names with a comma.
this is what you need : Kickstand Switch Eliminator
my bike is standard with full termi installed - getting on for 25K - 2010 S touring - serviced etc.. daily use it so am getting more and more...
at the last take-fairing-off job I did, the rubber wasn't on properly on the snorkel, this meant that the ram air effect I guess was reduced, this...
my recommendation would be to change your starter/kill switch - I am on my fourth. Same symptoms in my case bike started to cut out at motorway...
hmm, sounds like you need a new switch, that's 49 gbp or something like that plus a good sunday afternoon or two : take fairings and tank cover...
Update on this thread to finish off... The airbox has now been replaced (GBP 90) but a right pain to remove btw, take extra care when tightening...
Even if the bottom screw will 'stay' in I will not be happy that the 2 at the top are spinning to when it comes to the next time to service. so I...
So plan is try and remove airbox and try and get at the screws from inside. Here is a pic of the R/H connector that I am struggling a little as...
[ATTACH] [ATTACH]
pics of airbox intake - missing screw at bottom. this means the snorkel will 'lift' from airbox ... so there wont be a seal, other 2 screws...
zezzzs ok so the kill switch wiring harness goes all the under... the gas tank so everything needs to come off. bike apart, tank removed...switch...
Update : Kill switch ordered - 51 gbp Dealer said an intermittent fault points to probably that there is corrosion and is the switch and...
So riding home m25, and bike cut out (dash stays on, revs off - down to zero)...coasted to hard shoulder, clutch in and start button but nowt....
Have always had Dunlop sport smarts and now the smart 2, omg they are good, especially the new version, I looked at Pr4 and they do look good, but...
evening - sorry missed thread and ur q's - the wire mesh under the grip goes round 90% but theres a gap where the grip is glued that's the bit u...
evening not carbs u right but i do have to check the throttle bodies as defo a sqeak there. have full termi and ecu so valve mech removed. yes...
Morning all, Had my mts12 since 2010, all good and have the fortune of riding on motorways to work almost everyday. Particularly on one part I...
Spider grips dont do direct - so you need to go this supplier :...
OK I have 'experience' of this The process is as follows - which seems to work well : 1. Buy spider grips - you will need to buy the specific...
I had heads replaced at same mileage 15k, now on 24k, no oil leaks to speak of, and I do use bike most weekdays. can you maybe post a picture of...
