Separate names with a comma.
I am absolutely sure the o rings you supply are fine as I can definitely feel the contact with the bore. i would still like to know the answer to...
The push rod is like a prick in a shirt sleeve on my bike but I can feel that the o rings are making slight contact with the bore. However I do...
I believe there is a needle roller bearing behind the lip seal. It needs oil lubrication from somewhere. There is an opening.
Wouldn't failure of this seal show itself by leaking into the clutch? I assumed the rod would be covered in splashed oil where there is a gap in...
Thanks for replies. I will remove any sharp edges and try assembly from the left side but I cannot see what difference it will make. I have...
Hi I have had a very minor leak from this area (clutch slave side) for a few years on my bike. I have replaced the push rod o rings several times...
Its the Termi assymetric? System. I believe it uses the stock parts. I am not sure why this would be relevant? Its the exhaust pipe cover by the...
Unfortunately the Ducati Performance Carbon Fibre exhaust cover and all the fixings fell off somewhere at the TT. I want to get a replacement and...
Fitted new battery and all good now :-)
My 999 battery was low and it only managed to turn the engine over a few times. I connected an Optimate for a few minutes and then had another go....
2 of us going from Heysham 14.15 on 1st June and back on 7.45 on the 10th June. Hoping to take my 999 (if its ready and my hip can stand it!) and...
Yes, thanks:handok::yum:
Sorry, just spotted your reply. I didn't have a banjo bolt to try but I would think it would work. However because of the poor quality of the...
Deeper threads are perfect and there are 5.5mm of them which is plenty for this application. Just need to get the optimum M10 x 1 screw now. I...
Even better, I could just go and buy a new Ducati. Problem solved. Thanks very much.
Yes it is definitely M10 x 1mm pitch. The head diameter is small than an M10 Cap head screw. Hexagon socket is the same size as the M6 engine...
It's a 2004 999 but I suspect most use the same plug.
I tried nipping up the drain plug and have stripped the thread:rage: I feel like there may be extra good thread behind the front 7mm that has...
Ok, thanks.
Hi. Can someone tell me the correct size of the well nuts fitted into the bottom of the fairings? I have some spare M6 wellnuts but the rubber...
