Separate names with a comma.
I have a base model MY03 53 plate Bip in red, currently in mono form, which may be for sale. Its tidy and clean with 10k miles on it. Much...
Andy, I can recommend this one Automotive Engineering Services | South Cerney Engineering | England is just north of Swindon. Have been doing...
Michael, regulators can fail to low, no or high voltage. I have had one of each on my 748(s) and 999 over 15 years. A regulator failure to high...
You can get them really clean (like new) with nail polish remover or any commercial solvent based on Ethyl Acetate, it works as a carbon solvent...
Fin, first thing to check is the quality of the earth connection. I have had two similar instances, one with a GS550 blowing what were very...
Olly, when you bridged the two wires (pink and blue) did you get both full sets of indicators and the idiot light to work? If so with it all...
Olly, the plug has three wires, black (31) is earth, Light Blue (49+) is the supply 12v from the fuse box, Pink (49a) is the load to the lights...
Olly, have you checked fuse 3 (3A, LH switchgear) in the fuse box on the rhs of the tank, also make sure the large 3 way connector for the ecu...
Ricky, some are M6x1 and some are M8x1.25, easy to tell which one you have
There were some that were registered as late as 04, I have also heard of an 05 which had sat in a show room for ages before being sold at a hefty...
Give Rich a call at Louigi Moto (south west of Bath) 01761 453366 Louigi Moto // Ducati Specialists and see if he can assist
Bob, a word of caution. I got rear ended by a BMW 530 on my 748, the subframe and rear wheel took a 30mph impact from behind whilst the bike was...
Jet, that looks like the RH switch connector block, it is shown in the factory service manual wiring arrangement photos as unsealed on the backs...
Paulo, both the part numbers you quote come back as 29mm valves. Be wary on the valve spec for the 916 as they used 29mm, 30mm and 31mm through...
Hi Scott, see attached which may help, suggest that is also 30-40Nm. The setting given is the torque setting when tightening the cap whilst...
Scott, factory manual says 30-40Nm (if you mean the adjusting screw 34920101A with seal/washer that sits in the fork bottom above the the axle clamp)
See Shazaam's gearing variations and chain table Ducati Sporting Club UK - View Single Post - Changing ratios - Rear Sprockets (15-39 is a 96 link...
Dave, the clutch master is a PSC13 (according to the factory issued repair manual) and they are available imported for around £120 if you dig...
Ring Moto Rapido and ask for Craig. Alternatively (from France on ebay) 800056742 | eBay £5.01 for the knob 77640021a | eBay £2.71 for the screw
Kie, I would use a larger capacity connector (say 12awg) for the ground wire at pin T, that grounds everything (all forward lights and the clocks)...
