Separate names with a comma.
Rear paddock stand for MTS 1200, used on a 2010, possibly suitable for current models? Can be seen in use, in avatar pic. Unit has scratches from...
Ok, so at 89kg in my pants, I am looking at 6 turns out then? Will give it a go and report back once I collect next week.
Just been looking at one of these in the showroom and the 2 arrows are directly aligned with each other. Does this mean the preload nut is fully...
As a slight aside, I crashed an R1 at the Nurburgring some years back, the bike sliding into the barriers. A bit of bashing about and duct tape...
Do I take it that none of this info is in the manual?
Feel for you Tonic. After posting recently that I would keep my 2010 until it packs up, thinking it wasn't worth much, after a decent trade-in...
Mines a 10 plate, went through 29k miles yesterday on a 300 mile day out to North Wales and didn't miss a beat. Ok, it's had some major problems...
Yes, they are in the shed in a box. Need a good clean up, but not too bad condition, few dinks etc.
[ATTACH] I've got one thanks, a '76 Kettle. Wasn't complaining, just agreeing with OP that I won't be shelling out £17k plus to do it all again...
My Multi is 7 years old now, had most of the major problems dealt with (new cylinder heads, DES controller etc) and at c.30k miles isn't worth a...
Thanks for the offer, much appreciated, but already fitted a new battery this AM. :upyeah::)
Can't believe that after 7 years and 3(?) iterations, they still haven't managed to get on top of this noisy screen issue?
The 14 seems to be 15mm wider than the 12 and I'm not sure if it will fit comfortably in the tray? There is a rubber AV 'boot' inside the tray,...
Bit boring, but my 2010 has just eaten its second battery, first one at 4 years and now only 3 from this one. Always kept on battery maintainer in...
Cheers guys, it was a 5 minute job. Opened up case, squib of cleaner and managed to ram a Q-tip in the gaps (quite a bit of dirt), jobs...
Dropped mine doing a 180 turn over a high kerb, 2 years ago and it ended up partially upside down. The combination of R&G axle protectors,...
Cheers, will give it a go. Anything to look out for when undoing casings? I won't find tiny springs and ball bearings jumping out all over the...
Tried a few searches but no luck. My 2010 multifunction switch has stopped responding, so no range, temp, run time or ability to change...
You're not the 1st! Did the same a few years back with mine, but I had failed to put the side stand out, clipped the Ortlieb bag on the back seat...
I have the Givi Trekker 2 helmet top-box on the SW plate, without the under spars and it has held up ok for 15k plus miles, although the plate did...
