Separate names with a comma.
Michael, if the EOBD light indicates a coil fault it will stop fuelling that cylinder so you will end up driving a single that sounds a bit rough...
Check this thread to see the coil, https://www.ducatiforum.co.uk/threads/749s-firing-on-one-cylinder.76400/ they are stick coils held in with a...
Pete, for the wheels refurb there are a few on here who recommend Steve Turner in Melksham, so not far from you...
Gunk, scrape the worst bits off with a screwdriver to get in the crevices then work the Gunk into it with a small paint brush, leave it a few...
Or don't bother to fit the upper heat shield and just go with the lower one
Bob, 2 x M6x1 'special screws' which fit through some spacers with heat resistant washers into the bosses welded to the upper part of the standard...
HYG [ATTACH] [ATTACH] [ATTACH] [IMG]
I have been riding a 748 without that heat shield for nearly 13 years, you don't need it. Just need the heel plate and the heat shield that sits...
Factory tool 887131058 is the same for almost all Ducatis for the last 30 years. Of the aftermarket ones on ebay, some are not machined to very...
If you want it done by a specialist; Mark Hill from MHP can do them, although they have a quite a backlog, they do quality work....
It is odd as the part number cross references across many bikes as 631400041A and shows as M8x1.25mm on the cross refs, the factory books for both...
Birdie, the 748 factory manual I quoted from is the MY02 748S version from May 02, just checked the bike (and the 999) and my nipples are M6
Messer, factory manual says they are M6x1, the unions are specified at M10x1. Best check what came out
Fraser, I have the DP one (the good one similar to 69920641A) for 748, 916, 996 and 998 and it has two sizes on the pin. Just measured it and...
David, I see you had no replies, have you got the factory manual from here...
Jack, same rims, and the Ducati spec is for 190s on the 996. Ducati does the same profile change between the 749/999 which also ride better with...
Jack, 180 is very much better on the 748 rims and is what Ducati spec for the 748s, they spec 190s for 998s on the same rims. I too have a...
FWIW the factory manual process to obtain the dimension Derek refers to is attached, their diagram may be helpful
Mary, are you using a dial gauge to measure the distance from the shim face to the tool shoulder or doing it some other way?
John, if its any help the ones fitted to the 748S models are the same as the standard ones on the 996s and some Monsters but are not the same as...
