Separate names with a comma.
Before fitting the RHS rearset, as the original rearsets were Rizomas, they use a different actuating rod, spring, brake switch adjustable bolt,...
Front wheel speed sensor and shims fitted, using Pro Bolt M6 x 15mm flanged hex bolt, torqued to 8Nm. [ATTACH] Front mudguard fitted. Wheel...
No it was painted using a special high temperature paint by my local paintshop (AirFx in Norwich). They also painted the front calipers.
A couple of minor set backs. Clearances with the Termignoni exhaust are TIGHT. So much so that I have had to dispense with the rear reservoir...
I might well do in future with some carbon braided ones and dry break connectors but that's something I will leave for now as I've other...
With that job done I had to fit the rear carbon shark fin chain guard. This is held in place by the hydraulic line p-clip on the swing arm and on...
So started to make s some real strides today. First off was sorting out the RHS lower wiring branch and connectors. This is a bit of a viper's...
These arrived today. I ordered a set of stainless steel O2 reducers for the rear headers as only two were supplied with the Termignoni exhaust...
With the plate fitted I could turn my attention to the LHS lower wiring loom, which includes the sidestand switch, gear position sensor,...
More MotoCorse parts. This time it's the LHS support plate. This comes in two pieces as it features an optional side stand delete section for...
Arm fitted. Used some marker pen to position the angle of the arm correctly on the splined shaft, before I removed the OEM one. Pro Bolt M6 x 20mm...
Here is the splitter and shorter drain tubes, that convert the dual line setup from the fuel tank into a single line, where previously there were...
Clutch line fitted and Stahlbus bleeder/banjo bolt. [ATTACH] Front sprocket torqued to 55Nm, then fitted the Ilmberger carbon sprocket cover,...
Front brake line guide installed on main frame using RaceTi flanged torx head bolt, M5 x 10mm torqued to 5Nm. [ATTACH] Oil cooler line...
As others have said Dielectric grease every single time. Yoiu don't need to smother it on. just apply a thin film across the pins of each...
Really long day today at work. Not much chance to work on the bike and two O2 sensor adaptors short, so have ordered a pair to continue with the...
Three long flights today in mixed weather conditions. Loving the challenge of being back in the air after my 18 month hiatus. On the AW139 having...
Wish Brands Hatch was compliant. Undeniably a much better viewing experience than Donington or Silverstone, the lattter being what it is. A flat...
New sprint filter arrived today, courtesy of Steve Smith. Thanks again. [ATTACH]
Crisis averted! Switched the link bolt around and now there is plenty of clearance. A noteworthy point, if anyone else intends on fitting the...
