Separate names with a comma.
Getting there with the engine[ATTACH] [ATTACH]
Interesting looking bike :cool:
When I removed one, I used a large hose clip, to prevent the bezel from deforming too much. It did help, take it real slow.
The bezel is steel and not alloy, its a pig of a job and difficult to put back on as securely as it was. I have painted a needle with success...
A while since my last post. Been busy with life, but thought I would share my latest work. Got the shimming done after using the donor ST2 gearbox...
Bike colours https://www.bikecolours.com/
[ATTACH]
I have an ST2 lid you could cut up, its higher than the SS but the base is the same. £25 inc postage
Nice touch!
Merlins blood does a great job on wheel/caliper grime
The issue is getting them out, they can be in extremely tight, may need heated and to unscrew them you need a double nut at the end, which there...
Thats bad, first time Ive heard negative about them though
Ive found their products great, Ive had two looms and a starter. I havent however ordered anything else. Sorry to hear of this quite poor service
No, sorry, I guess it wasnt exactly the same. I had a coil wired the wrong way round, but it was my fault. A simple swap round of the polarity and...
This exact issue I have had
The good ones have an 'O' stamped on the end as per below [ATTACH] [ATTACH]
The studs should be dark in colour. If silver then they are stainless and are prone to snapping so are best replaced. It has low miles so hasnt...
A 39 will give a nice improvement on acceleration.
Id give you £50 :)
Holy thread revival!
