Separate names with a comma.
Okay, this morning I got the manifold of. There was a gasket in there but a section of it was missing. Put it back together with a new one and...
Ha ha, thanks. I'll check that channel out. Bike made it to the shop so will get them to sort the manifold gaskets while it's there. The lesson...
Thanks. Got two new OE plugs on the way. The good thing about the bike Vs the cars is that I can have it half torn down and back together in an...
Went out for a ride. Improved but not fixed. Will have to get the air leak sorted and try again
Now that I have ignition, I've checked for air leaks again and found one between the manifold and head on the upper cylinder. Unless my eyes are...
I've got plenty of experience working on cars (though all EFI) but this is my first bike. I did order new CDI units but Royal Mail lost them. I...
There were a few issues. Original issue a believe to be dieing plug, perhaps with ignition on that side being slightly weaker. I changed plugs...
I had the wires backwards :weary_face:. When I pinned it I was looking at the wrong end of the plug when comparing to the diagram. It's running...
Okay, fired up the bike and the exact same issue. Super low RPM, opening throttle makes the exhaust noise louder but the RPM doesn't increase at...
I put the plugs in as they came. What's the weak part, the coils?
It's around .61, so in spec. It was around .63 when I took it apart originally.
Okay, had it apart again and redone it. This time I got a dial gauge down the cylinder and I didn't have a degree wheel to measure the dwell, so...
Urgh, not sure where to go from here. The bike is barely running now. I put a timing light on it and it might be a few degrees out but I wouldn't...
I second K-nuts. They lock well and can also be had in a smaller hex size if space is an issue (made life a lot easier on the Lotus) I also use...
Pickups changed over last night but didn't test it as waiting for the RTV to dry. Did they use grey RTV from the factory or a gasket? Only...
The bike came with this issue but unfortunately the cold was enough to finish off the fork seals, so it will be going in for that.
I believe it's adjustable. I've got some on order as well.
It's low milage but definitely not untampered. The loom is a bit of a mess, though I've been through it and couldn't find anything that would...
Righto, fair enough. Hopefully when I open it up, I'll see something visible on that sensor then.
I originally thought fuel as well, or perhaps air leak but I wasn't able to find one. If you run the bike and pull the plug, it comes out damp and...
