Separate names with a comma.
CK if I measured 12.53v (across the terminals) with no load on either of my Bikes I would be off to get a new battery as the battery would be on...
Have you recently changed the spark plugs by chance or has this just started happening recently?
Madge, get a length of wire and short between the battery - post and the shell of the lights, that will confirm an earth breakdown and takes a few...
Looks to be all on the same feed from the fuse box, are you positive the fuse is ok (light blue lead away from the fusebox at fuse position 4...
CR, similar figure (124) on mine after a set up by Rich and custom map by Chris. Ducati quote 124 at the crank for the base MY03 motor, not sure...
FWIW I recently got a new one from Ducati (Moto Rapido) for £27.88. Also got the yellow ignition relay for £9.51, the two relays are often listed...
M8x1.25, torque for them is 22 or 23Nm on greased threads, the manual lists the two steering head bolts but does not indicate which one is 22 and...
Manual says M8x1.25, I think Nelly did a typo, the manual does not specify its length, torque is 25nm +/-5% Best get them from a dealer, they are...
As an option you could consider a Barnett basket. I have the Barnett alloy basket with stainless inserts and use alloy plates (usually oem as...
Cam bearing end caps or inside the clutch basket
Messer, bleed nipple is M6x1 and it looks like the banjo is M10x1, the manual refers to it as a "Front and rear brake system bleed union"
Carlo, I assume you already looked at this https://www.ducati.ms/forums/56-superbikes/389266-ducati-748-flaking-rocker-repair.html The part...
Carlo, gather the flakes and get a magnet, if they are magnetic it will be obvious and will give info that will eliminate some of the possible...
Later versions of the coil are less susceptible, best to check the cleanliness and location of the connector which on early models is right on the...
I have tried to unstick the preload nuts on my 748 on two occasions with the shock fitted, both of which resulted in shredded knuckles and damaged...
[ATTACH] The one on the right has been refurbished with the stellite inserts. As Duke stated all Testastretta engines can be afflicted, some...
Carlo, your bike is a MY01 registered in 02. The problem most affected bikes built in 99 and 00 which were MY99 to MY01 (roughly coincident to...
Andy, they are on the same chart that Chris Steadman printed out after a day in his dyno. Pretty sure it was a before (in the morning) and after...
Carlo, to give you an idea of what can be achieved with no engine mods here is what came out of my journey along the same route. MY02 748 bought...
You need to apply lots of heat at the boss then give the "nut" part a crack with a hammer and a cold chisel on the flat of the "nut" then repeat...
