Separate names with a comma.
i think you should try without the power commander fitted. with issues like this, i try to go back to basics and remove as much aftermarket kit...
so a quick report after the first run out, 95% was good to go, but some checking and adjusting was still needed.. i replaced the front spark plug...
First run in Oschersleben So far so good......! [ATTACH]
Well it looks the part, so far so good :) [ATTACH]
So back together and ready for it’s first run out on Wednesday [ATTACH]
So i thought id make a quick update, i got the wiring Loom back from UK after a having it checked over and some small repairs to the Run Stop...
brake adjuster rod pn 11720452A (21 UKP) Pin (bolt) pn 82113811AA (6 UKP) should be all you need
i have used the GPFAX pads, and they seem a good option.. not tried the ZO4 yet though
https://app.box.com/s/ubnmxoeq7ii6ouqy3jd8 link to the alert/ bulletin
as above you will have to take off the nose fairing and you will see on the left side a square white block connector, it fits here. ill take a...
So back home again and while i was away sent the non ABS loom over to the UK and John at Track electronics is doing some small repairs and a new...
without knowing the differences in Cam timing, compression, exhaust etc from the RS to the R model would say that there might be a completely...
Just looking at your build on another thread, i would go down the Individual mapping route.. it might be a good idea to speak to MotoRapido and...
looking good Monners, and a verz intersting build. i also have had a few boxes from Ben tip up at home while i was away
race and evo models have different facilities, as the Race model allows changes to the ignition map. i have changed over 3 RB evo models now, and...
also a vote for the above comments, i have DP rearsets and the DP race seat and one seems not to work that well without the other.. but together a...
I have one i may not need, i will dig it out when i get home..
https://www.racefoxx.com/Tire-Warmers these seem to get good feedback, and are not so expensive as a start
i understand the only way to 100% check is to get a dealer to read the firmware version. i also asked the very same question when i had my 'update'
it should have a full 50mm exhaust including manifolds, it will also have a twin injector throttle body but small P6 ecu with single pick up (and...
