Separate names with a comma.
Cheers, Good recollection you have - I also recall them being set at about 1mm below. I pushed them in a little further - the method was push a...
Can you tell me how your cush drive to sprocket carrier is set? I'm replacing the cush drive pins and rubbers on my '97 supersport, I put the new...
So test: - AC VOLTAGE at PICKUP COIL - starter motor engaged Disconnect plug form CDI; Should be 0.3-0.5 VAC. peak voltage produced...
Cheers Desmo. I wondered if pre-used would be worth it - If they not worn towards the limit, then I suppose why not? Bear in mind, I could opt...
Here's a couple of videos, one with chain attached , one without. I reckon it's mechanical, and suspect the cush drive. Heard a little clunk is...
Not precisely beforehand, no. Had been standing about two weeks whilst i got new pick up coils and sleeving together. I had prevoiusly been right...
The problem persists, cannot quite figure it out - insightful directions would be appreciated! I checked clutch - all seems well - no excessive...
He ticks over fine though. Yet first happened after a mile riding, shortly after the freeze. Last time happened at set off. This winter is first...
Oh. Interesting. I have disconnected my carb fuel bowl to oil line heaters, because of a slight seepage of oil and the banjo thread length didnt...
Checked the static timing, in no hurry. It's tricky to do in conjunction with setting the gap given the mechanism. The main problem was lining up...
Yeah, its hard to admit - damn frustrating when youve made up a new sheilded cable too - like a nightmare!
Upon further reflection: Although this occurred first ride after replacing the pickup coils, the bike did operate well for one mile without...
Thanks for advice. I’ll do it.
I took care on that point.
Right then i’m convinced. Muchas Gracias! i’ll have another go at the pick ups’ gap and timing. I did take great care, and set gaps at 0.65 mm,...
Could be that; i can add that the gabbing isnt confined to taking up drive, it continues as i open up and will not die away.
Adjusted chain tension and rode. Chain is well oiled. I can rule out chain tension. As I take up drive from rest, the drive train snatches...
ON tha basis, we can rule out the clutch bearing. Sounds more like the last. Thanks for that insightful set of clues. Off to test now.
I’ll look into that because i have so much town riding.
It’ll be interesting to see. I feel more confident now in taking a look. Ill check the sprocket bearing in neutral by hand, chain off if...
