Separate names with a comma.
Ihave made a desicion, and cut the heads! First off i have given myself a chouce of step on no step by looking at a spare termig system i have,...
Steve, yes I have looked at the heads by these folk and with some parts I agree and others I disagree, I don't want to get into welding the ports...
This motor is based around 944cc je pistons 94mm, with more headwork than i usually do, i have plumped for a 45mm inlet on these and stuck with...
Sorry guys, i was away from the puter for a couple of hours. So Al, i say the same, what do i know? i have been cutting heads for many years now...
No, new header is 43 id, i feel 50mm is just too big for one of these motors with the limited RPM. Port size std is 35mm so a 4mm step both sides.
Hello all. i am currently modding a set of ss heads for my latest project and have come across a problem where there are may correct answers I am...
I pretty much agree here, i think they are a little too long and may encourage the loosening effect that some have already mentioned. i use an...
On a seperae note: i saw some settings on here for the ignitech dwell values, any one direct me to them as i have lost my way.
As lucaz said default is 1.5 turns, if you look in the manual it tells you that any more out and the pilot is too big and any less the pilot is...
Grunt, how did your ignitech woes pan out. i had a play with dukedesmos ign on thurs and think he had a similar problem as you had. also i did...
Lots of comments here i agree with particularly the one from luca. Chewy does hit the nail on the head with the bench testing and getting the...
1037sps, i like your cunning. its crafty ideas like this that keeps everyone on their toes. Not a bad idea for a plod test i think!
I only had two problems with the fcr setup both on different bikes, one was dirt (looked like rubber bits) in the needle seat, the other was the...
What i am trying to acertain is the angle of the front carb, there are some manifolds that are sold on the internet that set the front carb at a...
What angle are the float bowls sitting at, is it the front or rear cylinder, and have you got both carbs as downdraft or the rear as a sidedraft?...
So 6 months later, how did we all do? i am still messing with the ignitechs and now need some info on adjustmens in the dwell area to compensate...
i may just have what you want, pm me.
Totally agree here , 8.5k with no load is no good. 4500 is the recognised rpm. what do they do with old cars that dont rev to 4500? do they just...
Now this IS getting silly, you all should know by now that only Italian virgin olive oil should be used. i think they still do a 20w-50?
MY TWOPENNYWORTH: Any good oil will work in the dry clutch motors, avoid car oils in the wet clutch motors for obvious reasons. As for the car...
