Separate names with a comma.
This is what I used. Anything similar will work well[ATTACH]
I've been chasing one for a while as mine was leaking. Have gone with a S4 Monster one for now but the V panel doesn't fit as it's a curved...
I can't remember. It was about 4 years ago. I'm almost certain that they are the same, as in revertible back and forth. If you have a paddock...
I have a 1098 stand on my 916 748. It's a perfect straight swap. I think they are all black but you could sand off the paint or put silver on it....
Unlike a car, when you turn the key, it will only light up if the fuel is low. These are known for being a problem. I had one sender that was on...
Make sure that speedo ring in the wheel is not bent. The tangs on mine were bent a bit and so no speedo reading. THey bent back and now it works...
I have this cover on my 748/916. It's nice. You need the gasket to keep it from hitting the pressure plate. Installed dry work but put all the...
Drill it out and then helicoil the thread
They're available on ebay through Gotham Cycles and many other retailers. They are a pain in the arse but worthwhile[ATTACH]
Not certain Olly. I never count them but I think it's a couple more than that. I can count them when I get home from work. Cheers
If you get a stand that stays down seriously consider fitting the neutral safety switch circuit to ensure you can't ride off with the stand down....
This has come up quite a few times taht I can remember. For some reason Ducati decided not to keep a rebuild kit for the front MC. So unless you...
I'm not an expert and have not measured the valves but I would expect that the S4 exhaust valves will be noticeably shorter and not...
The 996 biposto is all red. The white number board at the front was not standard on any model that I am aware of. The SP/R models had the mono...
I'd count the front sprocket again. I don't think there is a 16T one available and from my experience with the 15, probably wouldn't fit. I use a...
Ohlins rear. TiN forks. seems that all the important bits are OK. Might need a new radiator. And it's black : unamused:
Looks like you need to swap over some of the internals from the stock levers, which is fine, but they look sort of feeble. What are they made from?
Fairly easy to exchange. I've done it several times. When you have the throttle bodies off you can use a perfectly sized socket as a drift/punch...
You can buy Chinese copies for very little (complete set of 3 locks including ignition barrel and fuel cap) but the quality is not great. Good...
Yes. Change of ownership of Ducati in 1996 means no more elephants on the parts (except leftover parts) and a change in the decals on the tank and...
