Separate names with a comma.
The whole engine is painted except for mating/gasket surfaces. When repainting, all loose paint should be removed and etch primer applied before...
If i remember correctly you only need to put spacers under the latch part because these two bolt holes are closer to the top as there is no seat...
I bought the hardware so that I can swap seats in a few minutes, including new light s and seat. You don't need to. You can swap over most of the...
Are you talking about the twin pinch bolts that hold the fork on the axle? Any screw like this is available from a specialist nut and bolt shop....
I have a cheap chinese unit and they are OK. Noticeably thinner plastic and won't last but mine is 3 years old and still going well. A cheap...
I have rebuilt the top end of my 748 into an 853 with new special pistons and rings. 916 cylinders are getting hard to find and the piston kits...
No problems Paul. You can see that the screws hit the mount for the oil cooler. I'm going to fit a spacer to bring the plastic panel out. It will...
I've just fitted an oil cooler to my 2002 748 (now an 854) I'm going to need spacers as the screw for the plastic v piece runs into the rubber...
Looks good to me too. I'd seal up the ECU bung when you get a sec too. Don't need the original sticker but they do look nice. I'd be inclined to...
He might need to check the clutch pack stack height. That situation indicates the stack height may be a little too short. It might be that another...
I agree that it doesn't matter which way they go but there will be a natural way for them to join the tank. There isn't too much room in there so...
[ATTACH]
[ATTACH] I doubt there is any difference in the cases of an 748R compared to a base model 748. This was a 748R case
I have Fren Tubo brake lines. Nice colour but a little inflexible in that they don't run nicely along the rear chain guard very well so i have...
I think most of us have been or will be in such a position at some time. I sold my 1981 Hailwood Replica for a similar reason in the early 90s....
Obsessive compulsive disorder? That OCD. I just have to get that right :-D
The belt can move the width of a 5mm allen key. Usually measured up between the two pulleys. Was a method used on desmoquattros, not sure if...
Before you put that bolt back in Liam, make sure that you polish it. I used WD40 and 400 grit W&D paper. It cam up nice and shiny which is what...
Probably not as rusty as some can get. I had one that would not budge after 3 hours of work until I got the tool and a large mallet/gimpy. I...
Like any difficult job you just need the right tool. So that you don't damage anything, get the drift tool or have a fabricator make one on their...
