Separate names with a comma.
Might be the starter then defiantly no spark at any plugs & multimeter reads 0 at plugs will check starter tomorrow but its only getting 8-10 v...
multistrada 1000 the starter turns over perfectly but there is no spark at the engine, im thinking the starter relay may be robbing the bike of...
Hello i've been having intermitent starting problems for a while with the bike sometimes starting every time and sometimes refusing to start. at...
Cheers mate clutch problem is solved notches were out of line , next problem is difficult starting & miss fire on rear cylinder when cold, more...
Had a look today and the splines were slightly out ,my stupid lol. So new bearing & no more boiling clutch fluid :-) , of course I had to bump...
Arrow when back at the same point it came out I marked it up, will have a look tomorrow thanks for all the help :-)
Is there anything that goes on the end of the pushrod? Nothing came out with it
Check tomorrow probably something simple like that :-)
At work at moment have re aligned it twice but will chec
Hello the clutch plates are admittedly quite worn will check the bolts again the lever is hard, if I back the bolts out a little movement returns,...
in same as i took of only problem is what pressure to apply to bolts there is no resistance until clutch is in fully locked possition
did them up with a small allen key just hand tight as forum suggests so hope i havent broken anything didnt apply any pressure didnt touch the...
pretty sure nothing was misplaced i've loosened the bolts a little and movement has returned if i tighten up to hand tight as guides seem to say...
Hello i've changed the bearing in my clutch cover plate today following the guide on the forums, everything went fine until i pulled the lever...
Thanks for your advice, if anyone can point out the earth points on the multi 1000ds & any advice adding earths would be a great help, winter &...
thanks its a bit corroded like most of the electrics on my daily rider multistrada and i noticed the engine cutting out if i even touched it :-),...
Hello can anyone tell me what the switch on the rear of the 1000 ds engine is ? its in a recessed hole behind the suspension connected to 1 single...
my multi 2004 1000 sometimes does this although mostly at 2.5k usually if i put it in neutral it will return to normal idle until i pull the...
Hello just thought i would update my post after checking the ecu mounting points for corrosion and finding none i have run an wire from the ecu...
Hi it had a new starter motor last year as i said when the bike has started once it will then start with no problems until cold again. The bike is...
