Separate names with a comma.
Quite right, the o ring does sit in a recess im the gasket and the block/ casing. the later models dont use an o ring just glue, and if you are...
I used the smaller Dyna coils (Dynatek) with twin outputs, no problems at all and fits in standard position easy. i used 3 ohm versions.
Chris, the third was fitted between and forward of the two, like a clover shape but pointing backwards. as for jetting i had similar problems, its...
The only problem i had with the four snorkels is the rear two are enclosed towards the back of the tank. the one with three showed more promise....
Are the 750 rubbers like the 900 ones , they are different sizes and differing depths at each end?
Try SPR racing in nottingham, probably do it while you wait.
A good tool but the pulley can be held with an old belt wrapped round, you still need the forked socket for the nut though.
You need a forked socket to remove the cam nut, either make one from an old socket or buy/ borrow one, dont be tempted to try to hammer it off....
A quote from historic vehicle club newsletter and shortcut to the article. STOP PRESS In the last issue of the newsletter we stated that Shell...
It already is!
Now been for a road test and also back to the dyno. initial results were that i had too much advance at 3k the motor bucked and spat back, it was...
It would be interesting to find out who manufactures these, as far as i know the only manufacturer is Gates, there is some twist here as these are...
Another thought as a reaction from the last post, my bikes are both two valve bikes, compared with a four valve bike the belts are doing less work...
Sounds like a reasonable answer, to yet there has been no mention as to the age of the belt? to throw a low ball in, "what if" the brand new belts...
A lot of sense here, we do carry on buying and abusing the service intervals, i think the belt question has to be in your own hands, personally, i...
It starts at around 3k because you cannot get a steady reading below that, short manifolds move the power UP the range, this is because there is...
Pump was from ebay, carb yam r1 mitsubishi pump, this is one, Yamaha R1 Fuel Pump 2001 | eBay lob the bracket away and use a steering damper...
I think, no, im sure that the fuel pump is part of your problem. when at full throttle there is no vac pulse to work the pump effectively, so the...
Best tell dyno jet to dump all those power commanders in the river then!
Out of interest, what carbs? jet size? what fuel pump and what pressure? i am using 39 FCR's on long manifolds, mains are about 165. it still runs...
