Separate names with a comma.
Try the engine temp sensor, they are favorite for faults, an easy job and not too expensive, 30 quid or so. its on the rocker inspection cover...
Take a look at the manifold rubbers, if its been left the can start to de-laminate from the ally stubs, this causes all sorts of issues at low...
I assume you have checked the compression on the faulty cylinder?
Hi, was asked by Imola to weigh some various pistons and rods to make an assesment of imbalance, i thought the info contained in the pm may be...
I do have an unmodded 900 engine but not in a bike, i have dyno runs from unmodded bikes.
Dorset? thats much too far to go on a ducati.
No go on the subframe, but a word of warning, due to the stroke differences and rod length differences the balance points of the crank assembly is...
Hi imola, i have seen the post from brad on his site and have spoke to him on various other subjects so i know his work, as for his comment on the...
If i can help with the gaskets i will, the sizes are .9 to 1.5mm, i had these laser cut to order. as for the st4 i thought these were 996 not 916...
I may have what you are looking for, i certainly have the heads, i also have a selection of pistons and barrels. you realise that the longer...
If "SPR are local" where are you based, i am in nottm.
So why not get the cylinder head machined out to accept the larger barrel spigot, easy job for a competent machine shop. they could also reprofile...
Good questions, as for SPR doing any of the work i will say yes, we are actually working in conjuncton on this, i use the dyno and they gain the...
Why dont the heads fit, i thought the stud patten was the same with the same spigot?
This has been an ongoing project since i got the bike new in 95, i have had three engines up till now and am just working on the fourth. the 100...
A couple of points to make here, as for the motor not being able to make power on the long manifolds i strongly disagree, i have a 944 monster on...
we seem to have gone round in a circle, of course its a dry clutch, early belt 900ss about 89-90 ish.
And a hell of a load quieter!
As i said in the other post , i may have the parts you need, certainly some if not all, pm if interested but i need to know details of the motor...
Is that "Just high prices"?
