Separate names with a comma.
found it ta... think I'll avoid that one for £100. looks like it's been dredged up from the bottom of the river Humber and a bent top bracket....
On the off chance someone has one laid gathering dust in you garage. Would prefer 848 evo one as they are now braced at the top mount but will...
Yep.... check the pressure plate bearing hasn't seized which is the normal cause
Mine started making a sound like a supercharger wurring from 4k rpm and vibrations through the bars/pegs.... not to mention all the metal...
50 Shades lol
More than likely that he's never had anything at all done with regards to any settings and it's still factory set.... mine was a pig for it when I...
Lady boy
Yeh. Looked at draught excluder.... Ended up getting some neoprene foam sheeting so just going to make my own. Cheers all.
just finishing a rebuild but the garage pixies have been along and I cant find the foam bits that come with a k&n which sit inside the air tubes...
Done at last.... didn't take me long lol. Had a local shop do it in the end and it needed some stitching rather than just folding over and...
Coming to the end of a 1098 engine rebuild being asked if I want the cam timing altered.... anyone had theirs done? Figures he's given me:...
That's one for you to decide really.... general rule is you'll make more lf you sell the bike as standard and the bling seperate as it's dead...
If you give ducati john a shout Ducati John he sends then off to some where in Lincoln. Just had mine done along with another two bikes he had in...
Love my 1098s and have no problem with it on the roads, wouldn't say no to an 848 either though..... hope that helps lol
Depends how far you want to go with it... After a main bearing failure on my 1098 it's been pulled apart. Bearings all replaced, front cylinder re...
Yes... drives me bloody crazy. Don't even bother with it if there's no price. Can't be arsed with the drama
Good point... on my third reg rec. Rad did go but northern radiators do a repair for £40 if the worst happens.
Should have been done but at 7k I think? it's the valve clearances so should have been done. Mine were way out the first time and it cost a small...
Use this as a rough guide. Settled for 32 front and 27 rear as hot temps. On my 2010 zx6r below running a 180 rear. [ATTACH] [IMG]'] [/URL]...
