Separate names with a comma.
Thanks AirCon - are you suggesting that the Hella is a twist fit?
Nice one, thanks George, you're a star!
Thanks George. Ironically, I was looking at exactly those sockets on Amazon before I posted on here. Was that section of plastics easy to remove?...
Ironically, I have a 90 degree one with 2 x USB sockets in the end. I chose it because it charges at the higher rate, so my phone battery doesn't...
Does anyone else find that Hella plugs tend to fall out of the socket on the dash? I did about 350 miles over the weekend, and had to retrieve my...
I assume that in effect you're having to run it in, as if it's a new bike? If you can stand the looks, I've recently acquired an air cushion for...
They look great! They actually finish off the front of the bike - it's how it should be from the factory, in my opinion. If I didn't already have...
Yes, I'm kidding!
My PIN was set up by my dealer when I collected the bike. Thank you for your concern for my well-being, it makes a pleasant change from most...
1111 then?
That's extremely likely - you'll need a £40 Healtech device.
Good luck, they're notoriously bloody awful. Go REALLY slowly on those three nuts, and use heat and penetrating spray, if you can.
Really excellent decision. In my opinion, and probably yours too, the 1260 is (although very fast) not anywhere near as characterful. In some ways...
That's a mighty fine looking motorcycle you have there, you must be really happy with how that looks. Some lovely upgrades too. The Arrow exhaust...
Have you loosened off the front header?
I had an SC Project pipe with short silencer on my 2013 1200S. It looked amazing and sounded like thunder! It was great, but ultimately I sold it...
Yes, that would work. Even a hacksaw would probably do the job. Fiddly little bastards - they seem unnecessarily small.
Just had a very prompt message back from the manufacturer, and unfortunately they don't do a version for the Enduro. I don't know if the outlet is...
I'd be interested in whether this fits the Enduro too - looks like a nice quality part, and a nicer design than the Delkevic. Would of course...
I had a look at my exhaust studs yesterday. Managed to undo two of the three. The third was hard to get a socket on to it due to the curve of the...
