Separate names with a comma.
It's not the most scientific method. But as the mains degrade you will begin to see axial movement in the crank pins. Which in no time destroys...
First I'd check the belts are ok and the tensioners are correct. Rig up an oil pressure gauge and see how the pressure looks. Pop the little...
Only the sticker is Ohlins. That's a Sachs for sure.
Here's my 2pence worth. Carbon is only worth showing off if it's been laid up by a bloody good laminator. In a quality mould. With quality...
Increase the rebound slows the return. And if excessive can cause the pumping down effect which will alter the geometry. Too little rebound will...
I'd I have to disagree. You'd need more rebound damping to control tyre contact patch. Too much rebound causes the rear to "pump down" making...
[MEDIA] With rebound you'll normally see a variation in the width of the tear.
That's a bloody good time. Re cold tear. Try dropping the pressure by 1 psi at a time and see what pressure it cleans up at. But I'd be cautious...
Pin diameter and rod are the same. Crown height is increased to compensate. Crank pre-load I measured (granite surface plate and micron height...
999 barrel is the same height as the 749. It's the Gudgeon pin - crown diamention that's the issue. Hence the need for the Pistal pistons. I...
As Monday's go mine was epic. Got to work normal time and by 12:30. We'd had our second power outage. Popped out to see my buddy Nathan @...
Noooo. Not one bit. I did give little H the faster lane. Even strapped a GoPro on a car for a few laps. Bloody funny to watch back. It didn't...
:)[ATTACH] SCALEXTRIC
Depends on where the rebound rod had been locked up. Don't worry always adjust from fully in. You won't need all 12 clicks.
I've got to say a huge thank you too Ian at Rhodes and Track in Northampton for trusting me on his lovely dynojet rollers. If your based in the...
I'm using an RTD ecu. And a Pi system 2 dash/logger.
Good news. Had a very successful 2 hours on the rollers this afternoon. Spent an hour running in and some mapping correction for the increase in...
The term Blueprinting was from the olden days. Where the draftsman drew the "blueprints of his design. With the preferred clearences, mass,...
If the small (generator support bearing) has failed or well on its way. The main bearing have gone I'm afraid. If your mechanically...
I haven't read all the posts in this thread. So please forgive me if I'm repeating anyone else. Pop the small cover off the flywheel side. And...
