Separate names with a comma.
Front cylinder OK? I seem to have the same problem with my rear cylinder, it was too rich.(Wish I was!!)
Well, I've had two sized up now, I resorted to cutting the tunnels down, one is still like it on my. 750. I've got some more needlesles here...
Up date, things are getting there. Now starting on the carbs, they look clean on the inside but are really bad on the outside. Anyone managed to...
Clutch route is the other side to the above, mine runs with the choke cable then onwards to the clutch cover.
The bike past, but would the owner!!
Up grade you starter wiring to 10mm, it makes the world of difference, while your at it!!:upyeah:
Well panic over. I went and doulble cheeked where we tip the waste oil at work and there it was. No idea how I missed it as I managed to pick...
I read some where that just replacing the retainers can sort out the valve clearances as the can compress over time. nice to see your getting on...
There not adjustables on my bikes, tried to match the thread today with a thread gauge but no luck. I'll have a look again tomorrow. Thanks anyway
Showa forks, lock nut on top of the damper rod that screws into the top cap/nut. Its at work so can show you on Wednesday Al. Looks like a very...
As long as your happy, the person who buys it should be happy at that prices!! Good luck
Well I'm doing the fork seals on the 400 and the first one was fine, all done in 20 mins. The second one I assumed had lost all the oil as there...
Too cheap??!! Keep it, you'll never get another like it!!
Was over there a couple of months ago picking one up, looks like a nices place, was only there for an hour though!!
I fitted the 12mm bearings with a 5mm spacer behind them that I made at work, works fine.
One thing I've found out over the last 400 miles is don't assume they should be set the same. One on my 750 is 4.2 turns, the other is 3.2 turns....
I've just fitted the high efficiency SKFs in my rear wheel, they were more expensive but are incredible, spin the wheel on your fingers and it...
Pre 94 have a smaller drive I belive and the wheel bolt is smaller/diffrent bearings. I think it will be an ebay job to find another good used...
Was up:upyeah:
I thought all SS's were easy to get into neutral, after all there is one between each gear!! I have just order two sets of slave seals from pro...
