Separate names with a comma.
Hejira I am well, at least I am not suffering riding withdrawal, you can't if you have nothing to ride. Cheers Gaz
Hairy, Crickey is there a time difference with Scotland you were up early. Thanks for info, it all goes to forming an opinion. Just for people who...
Nice, That's what I have when I put it back together. You're right Hi level cans, can you get me a set while your at it. Don't forget single seat....
Desmo, I believe they are adjustable, they have a hex on the to adjust to some circumfrential lines about 6 in total and there seems to be a...
Hi Hejira how are you. Thanks all again for comments Ok Ok I will change the seals, damb (which after market can anyone recommend or go OEM)....
Chaps thanks for comments. I just want to get the bike running (so I can ride it for the first time since I've had it - got to be 4-5 years now)...
Got a little bit of motivation back. I am stuck on the engine (Money) so though I would do a few smaller jobs. I have the forks stripped, and...
Not been on for a while (garage is cold), just resurfaced in last few weeks. Just wanted to wish AL all the best, he has contributed to a few of...
Nasher, I have a AutoCad file to cut from. I sent it to another member when he did a reno, not sure what happened? Search for this thread thread....
No Problem, really pleased the brackets fit and you are pleased with them. Top thread - can't wait for the tank. Cheers Gaz
900ss'er Have a look at this thread. Single Seat : Grp Or Glass Fibre? I have a .dxf file of the brackets if you want a go at making them...
I must admit bare ally and acf50 will be the way I am going - paint it once, paint it forever. But each to their own. Cheers Gaz
Mark9 Look at the thread I mentioned in your clock foam thread - Mk1 Superlight Detailed restoration the saga Begins by sim900sl. He did a full...
Mark9 No problem, I might email a few suppliers to see how much I can get a few for, may be 10 off. It would be good if anyone else could...
As mentioned I would stay clear of using taps to clean out threads. I have use a bolt of the correct size and ground a flat down the length of the...
Mark9 I have measured one up and have a .dxf file if you can find someone to cut it for you. I sent sim900sl for his restoration (Mk1 Superlight...
I saw that this morning, if I thought I could get it past the Mrs just before the holidays I might have it. Bit of a scratch but saw one in the...
Hejira858, Top and bottom sat in same on mine 0.8 - 0.9. Will the thread on the bottom yoke spindle take up a few mm tolerance if you are a bit...
hejira858, I think I got them off the MARKSMAN web site but also see ebay (this is example I have not checked the size of bearing). Seal for...
hejira858, I have just measured mine and the outer race sits below both recesses about 0.8 - 0.9mm probably depending on pain thickness. Have you...
