Separate names with a comma.
You could try a car headlamp polishing kit. I had a scratch on the tail light of my car and used such a kit to completely polish out the mark...
The SPS was made in lesser numbers and is therefore considered to be rarer, although it's possible that fewer SP's exist today as they are older....
The SPS has titanium con rod bolts and as they stretch they can only be used three times. The last time my 748R engine was rebuilt I was told...
I guess it depends on what you want to use them for? Ducati must have had a reason to change to titanium con rods and I would think that is due to...
No, Sp had steel conrods whereas the SPS had titanium conrods as did the 748R
Considering he worked this engine stand mount out from what I sent him above he did an incredible job. The stand was made in 2009 so it clearly...
I managed to find a few more bits of information which allowed me to have the engine stand built. I should add that apart from the stand I also...
Here are some photos of my engine stand made by a member on here who is no longer active I think. [ATTACH] [ATTACH]
I probably didn't portray what I meant which was removing the wheel from the bike for work on the front end, not just getting the stand from under...
The only drawback I can see is that the front wheel only sits on the stand so you can't actually take the wheel out without a proper front paddock...
I came across this today, a couple of totally maneuverable bike stands that would be ideal for my cramped workshop, maybe even for trackdays etc....
I only had the pads on my 998 when it was new but having purchased several 748 panels over the years none of them ever came with the...
Clearly, I misunderstood your post. I'd agree, replace the bleed nipple and give the seat a good cleaning out. Unless there is damage or dirt in...
Are you using the correct copper washers around the sides of the clutch fluid line? I assume the 1199 uses them as standard. If you do have them...
I use them on all my bikes and they make quite a bit if difference, worth the change.
Same here increase by £100. Looked at going third-party fire and theft and there was virtually just a few pounds drop.
The originals are quite long and on one conversion I did I had to cut one in half to make it the correct length. As above this is for the...
Had this on a track day, I got flagged down by a marshal and my caliper was on fire! Luckily rear disc was Ok but the rest was finished. Best to...
I remember seeing him for the first time in the Barry McKenzie film when he played just Aunty Edna as a one-off. Always loved him as Sir Les...
Yes, as I understand it, brake caliper bolts, studs and nuts for the exhaust ports and anywhere else where a bolt is subject to a shearing force...
