Separate names with a comma.
The Liquidation report from Grease Junkie. I must admit I got a bit bored with Wheeler Dealers after a while and no longer watch it, like many I...
Is this the grey\green colour or the silver of the later models? The Grey\green can be bought from RS Paints and the silver has a good match in...
An actual Ipod as opposed to the Ipod Touch uses a 1.8" hard disk drive. Like any drive it will fail over time. Depending on whether you use...
I use Spotify (free) and then use Audials to record the music and then keep it in a separate folder and also transfer it to Itunes. Audials is...
It's possible that they are just using a "library" photo that they have of older belts. Easiest thing would be to send them a message via eBay or...
A well known tuning company and I have purchased a number of items from them in the past. Using the RGV as a track bike is quite costly and at...
I have a VJ22 track bike, 2 in fact!. Nice bike but compared to my LC it's a lot more fragile especially when ridden hard. I went through three...
Teflon exhaust tape works very well. I used this for my track Suzuki RGV250 which uses slipon pipes to an exhaust flange in a very similar way to...
Try bleeding the clutch "uphill" or use a pressurised bleed setup (Halfords!) and see if any air comes out. If you have the clutch on your 999...
As another idea, have you checked to see if the slave is faulty in any way despite being new. Do you have any form of slow leak or trapped air...
I assume you did put the balls back correctly in the hub? If I had this trouble I would start all over again and check everything in the clutch...
No it uses an IAW 59M ECU which mounts to the battery box. It also uses a unique Powercommander due to the shower injectors. The airbox is the...
From Ducati.Ms The flat metal plates come in stock 2.0, 2.5 or 3 mm thicknesses. When the overall plate stack height wears say 0.5 mm, replace...
Have you checked the pushrod length? If it's an Oberon one then I think the instructions state the length of the rod, or they certainly give some...
Did you buy this slave cylinder as a new item? If not does the cylinder have the pushrod extension fitted inside it, in which case depending on...
If you didn't change the ECU chip it is highly likely to be running weak. If it's seriously weak you could cause some permanent engine damage....
Try putting the old slave back, measure how much the original pack opens up with the old slave and try and replicate the lift height with the...
If it backfires on the overun it could be running weak, which is not good for the engine. My 998 when new was terrible for blowing out of the...
Use worn friction plates to help get the correct clutch pack thickness, but make sure they are serviceable and avoid putting them in the centre of...
Have you set the clutch pack to the correct thickness. Slipper clutches do judder and sometimes quite badly when the pack is not set correctly....
