Separate names with a comma.
I too phoned them recently concerning my renewal, unfortunately I could not get a good quote for my 998, however they did make me the offer of...
Gowanloch Ducati acquired all the factory parts in a buy out for a lot of these models so they may have one. However they are in Australia, so...
On here too Ripoff Report | Westcountry Windings Complaint Review Harlow, Select State/Province: 1097590
Autotune?
Hyperpro or Nitron are both decent enough makes of Shock Absorber. If you want more expensive then there is Maxton who will custom build you a...
Engine parts are expensive, it cost me £900 in parts alone to rebuild my 748R engine. An expert eye really is required to strip and rebuild one...
To add to the above the 998 frame will allow a direct fit for a 999 engine and a 748R frame is the same frame only with the HT coil mountings...
I use white vinegar window cleaner on mine as it dries totally without residue. This not the cheapest place to go to but it will give an idea of...
The above two have already been mentioned but there is also Roy Thersby, not local but I have dealt with him in the past. Another possibility....
It could be your gun is cold, or in some cases too warm, the actual gun could be getting cold due to air passing through it which causes it to...
I too have a Hyperpro damper on my road\track bike. Bought for just £26 from eBay, a total bargain and barely used. Ohlins are good but very...
It depends on the year. Earlier models were more like the SP\SPS the later 2002 model had a lot of what has been mentioned above. The engine...
Yes, and therefore it should not be as rare as the SPS, however being older more will have been taken off the road for one reason or another. A...
The SP was made in greater numbers compared to the SPS. The main difference between the two is that the SP has Pankl Steel Conrods and the SPS...
Is it a UK model or an import? I have seen one as high as £25,000!!!!! for a virtually unused one down to about £4,000 ish or less for a not too...
The silver 748 was sold exclusively by Marcus Neiman and no doubt was an original Red\Yellow bike simply repainted to sell in their stores, hence...
I think you would be very lucky to find one now. They are made of a J cloth type material that disintegrates with age. I had one for my 748SPS...
I'd agree with the above, they are also early forks with 45mm brake caliper fittings and early fork bottoms. They have just been made to look...
I used to race there many (many!!) years ago, the circuit is short at only one mile and it was ideal for me as I was in a small class at the time....
A Power Commander only has a limited number of parameters, nine I believe, that you can adjust whereas having a custom chip made for an ECU covers...
