Separate names with a comma.
Does a Vincent normally have a RH rear drive chain? If not why the conversion? It looks as though he has included an additional transfer shaft to...
It would be interesting to know what they do at the end of the production line, I suspect they run it up through the gears to full RPM and then...
^^^ wrong front forks ?
^^^^^ Love the looped copper/nickel plated fuel lines presumably to allow for vibration of the engine and work hardening of the copper
That looks to be about 5m x 4m on a 200mm slab, I would definitely put reinforcing mesh into a concrete slab that size
^^^^^ circa 1956,7,8 - Ducati 125 ????
Rather than making the beads go through the pump (which cannot be good for a high pressure pump) would it not be better to introduce the beads...
^^^^^^^ Nice but too many Hardly Fergusons
Crankcases look a bit rough! Seriously lovely
Battery earth lead or power lead to starter motor, the little rubber boot on the starter motor end fills with water and the connector corrodes
Look at those knobblies on the Manxes - my guess around 1953/4/5
Is that the current race boss holding the bike?
[IMG]
Been there, done that - it is the screw by the side of the clutch push rod which when full of chain goo is invisible. Lucky it is not one of the...
Josh Brookes? or his dad?
Have you noticed the position of the centre line of the crank shaft relative to the centre line of the wheel spindles in the previous 3 pictures?
potential broken piston rings if overfilled
I think it was trying to improve rigidity between front axle/bottom and top yokes (twisting) and limiting the fore and aft rocking of the old...
USD forks have a higher un-sprung mass as the steel fork tubes are moving as well as the axle clamp and all attachments, where conventional forks...
I think it travels to the left, the two lower arms must provide some form of steering and drive is transmitted to the "rear" wheel via the surface...
