Separate names with a comma.
Don't have have your warm, dry space for winter fettling though...
Wow, in SW England, I manage to get 9 months a year. Put her to bed for December January and February
Is that 10 months per year or 10 months over 3 years??
I did see a Ducati service bulletin quoted some time ago that stated that ideally the inservice tension should be 90 hz but there was a lower...
Is that 10lb for in service or new though? The op is checking his belts for in service tension, not new fit and is there an Allen key measurement...
Maybe the 900s have a dash readout but my '96 750 didn't. In service tension is 90 hz Check it out with a phone app (Gates Carbon) and...
Been covered. Same applies
It would be jolly painful as there is a void with all sorts of gubbins under the cowl on a 999
It's air cooled. How and where do you measure the 40*? But yes, good idea to run it up to temp
I have replaced my pillion pad with a cowl and removed the pegs with no issues. As said, a cowl over the seat leaves the seat there and available...
Yes, good point. If you tension used belts to new belt spec, you will be over-tightening them as new belt tension takes into account initial...
Bob, It says at the top that Shell Advance Ultra 4 is the recommended oil for the engine lubrication circuit. This is a motorcycle-specific fully...
I would seriously surprised if it doesn't say good quality fully-synthetic oil. If you're sad enough to read oil studies, you'll find that fully...
Chain tension does affect change quality. It does need to be right. Ducati clutches do not all drag and cause problems finding neutral. If it...
Problems finding neutral are caused by clutch drag It's interesting that it should improve over time, does the problem get worse as the motor...
Melody Maker didn't think so. He asked me to explain their review to him and it wasn't terribly complimentary.
Strange indeed...
I put lighter oil in my 750 SS forks and they actually worked then!
Haynes never produced one. I wrote to them asking if they were planning to and they said not enough demand.
@chrisw is your man.
